Robbie Toys Dino Bikes Operating instructions

Hello, I've reviewed the user manual for the RTL Dino Bikes, specifically the 10" and 12" models. I understand their unique pedal installation, the automatic back wheel braking system, and the two clamp sizes for the seat and handlebars. I'm ready to assist you with any questions you have about these bikes.
The left pedal will not screw into the pedal arm.

Does the 10" and 12" bike only have 1 brake?

Which clamp do I use for the Seat and Handles?

Dino Bikes FAQS

The left pedal will not screw into the pedal arm.

This pedal screws in the opposite way – so to the left not the right- and will be a very tight fit, it will be easier to

insert laying the bike on its side.

Does the 10” and 12” bike only have 1 brake? – Yes

For these sizes and the age of the child riding these sizes, they are likely to lack co-ordination. As a safety

measure, the 10” and 12” bike has an automatically breaking back wheel when the child stops pedalling. This

means If they are going down a hill and/or are unable to apply the front brake, if they were to stop pedalling the

rear wheel would begin to brake and slow them down.

Which clamp do I use for the Seat and Handles?

There are two different sizes of clamps, the larger one is for the seat and the slightly smaller one is for the

handlebars. (You may need to loosen both slightly to fit over the bike frame)