Page is loading ...
Read Me First
Unpacking & Initial Setup
TW1730
UNPACK YOUR LCD TV
• TW1730 LCD TV (1)
• Remote control (1)
• 1.5V AAA alkaline batteries (2)
• Audio/video cable (1)
• RF (Antenna) cable (1)
• User's guide (1)
• Quick reference guide (1)
• Warranty registration card (1)
• AC Adapter (1)
INSERT REMOTE CONTROL BATTERIES
1 Remove battery cover on back of remote control.
2 Insert two 1.5V AAA batteries, paying attention to the
correct polarities (+/-).
3 Replace cover.
BASIC SETUP
1 Connect the RF cable from your antenna or cable TV jack to the ANTENNA IN jack on the back panel of the LCD TV.
2 Connect the supplied AC Adapter to the POWER DC12V jack on the back panel of the LCD TV and plug it into a wall outlet.
3 Rotate the power switch on the front panel downward to turn on the unit.
• When you turn the power ON, the screen appears and the POWER/STANDBY light is turned off.
• When you turn the power OFF, the screen goes blank, and the POWER/STANDBY light turns on.
1 2 3, 4 5
MEMORIZE CHANNELS
1 Press MENU to bring up the on-screen menu system.
2 Use the / buttons to select CHANNEL SETUP, and press .
3 Use the / buttons to select ANTENNA and press .
4 Use the / buttons to select TV or Cable and press .
• Choose whichever channel source you connected in Step 3 above.
5 Use the / buttons to select AUTO PROGRAM, and press .
• The TV automatically searches for all available channels and stores them to memory.
This takes approximately one or two minutes.
6 Press EXIT to exit the menu system.
From
Antenna
From
Cable TV
OR
LCD TV
L
-
AUDIO
-
RPHONE S-VIDEO VIDEO
VIDEO INPUT
For detailed
instructions
and descriptions
of features,
please
consult the
Userís
Guide
Quick Reference
Basic Operation & PC Connections
TW1730
WATCHING TV
PC CONNECTIONS
Questions?
DO NOT RETURN THIS
PRODUCT TO THE STORE!
Our Award-Winning Customer
Service Professionals are
Ready to Help!
Call Us!
1-800-736-7679
E-Mail Us!
Visit Our
Web Site!
www.govideo.com
Selecting Inputs
Press to display the desired input:
• TV (to watch TV)
• LINE (to view a device connected
to the Video or S-Video jacks)
• Component (to view a device
connected to the Component HD
input)
• PC (to view a computer connected
to the PC input).
Selecting Channels
• Use TV CH+/– to select
memorized channels .
• Use 0-9 to directly select any
channel. To select channel 100 or
higher, press the 100 button first,
e.g., for channel 122, press
“100”,then “2”, then “2”.
Viewing TV Status
• Press to display the input
source, picture mode, sound
mode, MTS mode, current time,
V-chip, and audio signal you are
listening to.
Adjusting TV Volume
• Use the VOL+/– buttons to
adjust the volume.
• Press the MUTE button to mute
the sound.
SPK
1 Connect a monitor cable from your
PC to the PC INPUT/VIDEO jack on
the back panel of the TV.
2 Connect an audio cable from your PC
to the PC INPUT/AUDIO jack on the
back panel of the TV.
3 Turn the PC on and check that the
Display settings are correct:
• A screen resolution of WXGA
(1280 X 768, 60Hz) provides the
best screen quality.
• Configure the screen color to 16 bit
or 24 bit.
4 Press the PC button on the remote
control to view your PC desktop.
• To change the aspect ratio, press
ASPECT.
LCD TV
PC
/
