shown without
factory subwoofer
shown with
factory subwoofer
A
D
E
F
Materials Needed:
// Hammer
Installation Instructions:
Flip up the bottoms of both sides of the back seat.
Slide the 3 threaded u nuts over the square holes in the metal seat support brackets.
Make sure the at side of the clip faces up. Tap in place with a hammer.
Set the DU-HA under the back seat and line up the 3 holes in the DU-HA with the 3 holes
in the threaded u nuts on the metal brackets.
(Note: If the DU-HA hits the jack, loosen the jack, turn it 180 degrees, then tighten the jack back into place.)
Screw the 3 included knobs clockwise into each of the 3 u nuts. Hand tighten until snug.
Install black plastic divider so the small notch is facing up and is closer to the driver’s side.
Install the foam organizer/gun racks with the plastic stiffeners by sliding them into the
pre-cut slot in the divider and the channel slots inside the DU-HA, making sure the high
side of each piece faces towards the front (as pictured below).
Safety Instructions:
Warning: Seat bottom must be latched down at all times while vehicle is moving.
Make sure the DU-HA is secured in the vehicle according to installation instructions.
Do not store explosives or hazardous materials in the DU-HA.
Do not place loaded guns in the DU-HA.
For further instructions refer to truck owners
manual or contact DU-HA, Inc.
07-14 Toyota Tundra Double Cab
Underseat Storage
Note: Images on the right show the factory subwoofer under the back seat. Not all models have the subwoofer.
Installation Instructions
DU-HA, Inc. // website: www.du-ha.com // phone: 1.866.306.DUHA (3842) // fax: 1.218.998.4013 // 306 Saint Andrews Street South, Fergus Falls, MN 56537
1
2
3
4
5
6
B
C
Fits DU-HA Part Numbers
Part Description Qty
A DU-HA Storage Unit 1
B Foam Organizer / Gun Rack 2
C Plastic Stiffener 2
D
Divider
1
E
U Nut Part # 12265
3
F
Knob 908B-3118-1.00A
3
60051 60061
60052 60062
60053 60063
1
2
3
4
5
6
DIVIDER – 60051
/
