2. Atdec
  3. TH-PPA-24-48

Atdec TH-PPA-24-48 User manual

  • Hello! I am an AI chatbot trained to assist you with the Atdec TH-PPA-24-48 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Step 2. Configurations
TH-PPA-24-48
Component Checklist
! IMPORTANT - Install Telehook Adjustor Pole as per installation instruction.
! This product supports a maximum load of 454kg (1000lbs.).
! The manufacturer accepts no responsibility for incorrect installation.
IMPORTANT INFORMATION:
Step 1. Check Components
Check you have received all parts against the component checklist and hardware above.
Adjustor Pole Plastic CoverExtension Pole
HARDWARE
Security Set Screw
(x2)
Set Screw
(x2)
Standard Socket Pan Head
Screw (x1)
4mm Security Allen Key
Security Socket Pan Head
Screw (x1)
2.5mm Allen Key
Existing Ceiling
Plate Bracket.
Sold seperately
and available from
ATDEC.
2.1. Configure components as per image below for a pole length of
24”.
2.2. Screw Extension Pole in a clockwise direction into Ceiling Plate
Bracket.
Extension Pole
2.3. Configure components as per
shown below for a pole length range of
26-48”.
2.4. Screw Extension Pole in a clockwise
direction into Ceiling Plate Bracket.
2.5. Locate Adjuster pole on Extension
Pole aligning the holes with the slot.
Adjuster Pole
24” Range 26-48” Range
Existing Ceiling
Plate Bracket
Slot
Holes
Installation Instructions
24-48” (610-1220mm) Adjustable Projector Pole Accessory
Extension Pole
Step 3. Assemble to desired length
No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published 22.05.13 ©
3.1. Insert the one Standard or Security Socket Head Pan Screw through the slot
in the Adjuster Pole into either of the 2 visible holes in the Extension Pole. Each
hole enables a different length range.
Step 4. Secure Position
4.1. When desired pole length has been selected use either the
Security or Set Standard Screws to secure position. Tighten with the
2.5mm Security Allen Key supplied.
4.2. Snap off upper segment of cable cover for cable access.
Cable
3.2. Move the extension pole to the desired length and rotate to locate in one of
the three slots. Adjust the tightness of the screw using the 4mm Security Allen Key
supplied.
Upper Hole
Lower Hole
27”
29”
....47”
26”
28”
....48”
Snap off
Installation Instructions
Cable
Cable
/