Page is loading ...
Before starting installation, verify that all parts are included and undamaged. If any parts are missing or damaged contact
customer service at (877) 698-4946. Not all hardware included with the wall mount is needed depending on your setup.
Drill with drill bits:
3/16” (wood) or 1/2” (concrete)
Stud finder 1/2” wrench
1/2” socket &
wrench
Phillips screwdriver
Hammer
[1] x 1 Wall Plate
[2] x 2
M5 x 30mm
M8 x 40mm
[14] x 4
[13] x 4
[12] x 4
M6 x 35mm
M4 x 12mm
[7] x 4
Short Screws
M5 x 12mm
[8] x 4
Short Screws
M6 x 12mm
[9] x 4
Short Screws
M8 x 16mm
[10] x 4
Short Screws
M4 x 30mm
[11] x 4
Long Screws
Long Screws
Brackets
Long Screws Long Screws
4M
[15] x 4
Lock Washers
5M
[16] x 4
Lock Washers
6M
[17] x 4
Lock Washers
Spacers for
M4 & M5
Washers for
M4 & M5
Washers for
M6 & M8
Spacers for
M6 & M8
M4 / M5
M6 / M8
M4 / M5
M6 / M8
Lock Washers
M8
[18] x 4
[22] x 4
[21] x 8
[20] x 4
[19] x 4
3/4” Lag Washers
(use 4 for wood,
use 6 for concrete)
[4] x 6
Anchors
(for concrete)
[5] x 6
[3] x 6
Lag Bolts (use 4 for wood,
6 for concrete)
40.6 ~ 61.0 cm
(16~24″)
B. MARK & DRILL HOLES
1. Tape this poster to the wall so the holes align with the studs. Hold the wall plate
[1] up to the poster and use the built-in level to make sure the poster is level. Put
the wall plate [1] aside.
2. Drill 4 holes 2-1/2" deep in the studs using a 3/16" drill bit. Remove the poster.
B. INSTALL ANCHORS
1. Install the provided anchors [5] in the holes, using a hammer to tap flush with the
wall so that the hinged end faces out.
CAUTION: This product is not designed for use in metal stud walls.
!
www.VIZIO.com
ACTUAL SIZE TEMPLATE
Use this hole
for concrete
Use this hole
for concrete
Use this hole
for concrete
Use this hole
for concrete
Use this hole
for concrete
Use this hole
for concrete
VMT37-60S
TOOLS NEEDED
PACKAGE CONTENTS
INSTALLATION INSTRUCTIONS
WOOD STUD WALL CONCRETE WALL
A. LOCATE WALL STUDS
1. Using a stud finder, locate two wood studs that are 16” to 24” apart.
2. With a pencil, mark the location of the studs.
DRILL HOLES
A. MARK & DRILL HOLES
1. Tape this poster to the wall. Hold the wall plate up to the poster and use the
built-in level to make sure it is level. Put the wall plate aside.
2. Drill 6 holes 2-1/2" deep where indicated using a 1/2" masonry bit. Remove the poster.
ANCHOR MOUNT TO WALL
1. Using a 1/2” wrench or socket, attach the wall plate to the wall
with the supplied lag bolts and washers [3] & [4].
2. Check the built-in level before tightening the bolts. It is important
to make sure the wall plate is level.
Note: Do not over tighten the lag bolts. Tighten only until they are
firmly against the wall plate.
CONTINUED ON BACK
1 2
Medium Sized
Screws
M6 x 20mm
[6] x 4
Note: You must attach your TV wall mount to a wall that has at least 2” x 4” wood studs to avoid property damage or injury.
A B
A B
Visit www.VIZIO.com to review our full line of HDTVs and certified accessories or call 888-849-4623 for more information.
See the documentation that came with your TV to connect the
cables needed for any device (i.e. DVD player, cable box, etc.)
you want to connect to your TV. Do not connect the other
end of the cables to the devices yet. You will do that after
your TV is mounted on the wall.
TIP: Create and attach labels to the cables, identifying
the cables to make it easier to later connect the cables
to the devices.
ATTACH BRACKETS TO TV CONNECT CABLES TO TV ATTACH TV TO WALL PLATE
ADD TO YOUR HOME THEATER EXPERIENCE
VIZIO BLU-RAY™
Bring your movies to life!1080p Full HD playback delivers crystal
clear images with lifelike detail and High Definition Audio puts you in
the center of the action.
VIZIO VF551XVT
LED technology brought to you by
VIZIO! Experience truly stunning
video with a 2,000,000:1 contrast
ratio and Smart Dimming for
darker blacks, 240Hz sps
™
†
for
smooth motion transitions and
1080p Full High-Def for sharp
clarity – plus enveloping sound
with SRS TruSurround
™
HD and
SRS TruVolume
™
audio technologies.
†240Hz sps displays 240 scenes per second by combining
advanced 120Hz technology with scanning back light.details.
HIGH-DEFINITION SOUND
Complete your total Home Theatre experience with stunning audio
from VIZIO accessories such as the Sound Bar with
Wireless Subwoofer.
Protect your VIZIO product with up to 5 years of added repair
service! Extended coverage begins when the manufacturer's
warranty expires so you’ll receive maximum protection!
Visit us online at:
or Call:
For more info on Extended Warranties
EXTENDED WARRANTIES
(888) 849. 4623
www.VIZIO.com
3 4 5
CONNECT CABLES AND POWER
6
TIGHTEN SAFETY
SCREWS
7
TV with a flat back.
TV with a curved back or obstruction.
A. Lay your TV face down on a clean, flat surface.
B. Insert the screws and washers into the desired holes in the
brackets [2]. Use the screws provided with your TV if they
hold the bracket securely, otherwise use the appropriate
screws from those provided.
Caution: Using screws that are too long or too short can
damage your TV. Use spacer [21] with M4 or M5 hardware
only. Use spacer [22] with M6 or M8 hardware only. Depending
on the depth of your TV mounting holes, spacers [19] and [20]
may be necessary.
C. Raise the hinged part of the bracket to reveal the hole in the
elongated opening and then insert the screws and washers.
D. Fully tighten the screws.
E. Loosen both safety screws from the bottom of each bracket.
• Review the entire installation/user’s manual and these important Safety Instructions before
attempting to install or use this mounting system.
• The manufacturer is not liable for damage or injury caused by incorrect
mounting, assembly, or use. The TV must not be larger than 60 inches (152cm) or weigh
more than 150 lbs (68 kg).
• Attaching a TV that is heavier than the maximum weight specified above may result in
instability and possible personal injury.
• Only attach this mounting system on vertical walls as instructed in the
installation/user’s manual.
• This product is not designed for use in metal stud walls.
• If you have any doubts about the ability of the wall to support the TV and the mounting
system, contact a qualified contractor.
• This product contains small items that could be a choking hazard if swallowed. Keep these
items away from children.
• Do not run any wires and/or cables near moving parts of this mounting system.
IMPORTANT SAFETY INSTRUCTIONS
CAUTION: For safety, we
recommend having two
people lift your TV onto
the mount.
!
A. Connect the other ends of the cables that are hanging from your TV to
the appropriate devices (i.e. DVD player, cable box, etc.).
B. Connect the other end of the TV power cable into a wall outlet.
Tighten safety screws using a
Phillips screwdriver.
/
