Page is loading ...
Installation Instructions:
When hinge (Surface or Concealed) is fully installed with all top
surfaces aligned, place HAGER TIPIT® angled block against
frame centered above and resting on top of hinge. NOTE:
There should be no gaps between top hinge surfaces and
HAGER TIPIT®.
Mark hole locations and drill pilot (5/32" drill) holes in frame
face. Secure HAGER TIPIT® to frame with security screws
provided.
Disclaimer:
This product is designed only as a "deterrent" to hanging objects from the top hinge surface.
HAGER COMPANIES assumes no liability due to improper installation or injury resulting from
tampering with the applied products. Sharp edges may be present at the bottom portion of
the applied hinge. It is recommended that these sharp edges (if present) be filed to
rounded edges or that a heavy bead of construction adhesive, epoxy putty or the like be
used to fill around said edges.
The Hager Tipit works on all the following models: Concealed: 750-134, 750-138, 780-110,
780-111, 780-112, 780-113, 780-114, 780-124, 780-208, 780-224, 780-226 Full Surface: 780-157,
780-210 Half Surface: 780-046, 780-053, 780-054, 780-155, 780-211, 780-259, 780-045.
HAGER TIPIT
®
**READ THIS FIRST BEFORE INSTALLING HINGE**
Concealed: 1" X 1" X 1"
Surface: 3-5/16" X 1" X 1"
HAGER TIPIT
Installation Instructions
I-CL00801
REV: - REV DATE: 11/29/2018
Page 1 of 1
/