Hagerco TIPIT® Concealed Ligature Resistant - Ligature Resistant Cover Installation guide

Installation Instructions:

When hinge (Surface or Concealed) is fully installed with all top

surfaces aligned, place HAGER TIPIT® angled block against

frame centered above and resting on top of hinge. NOTE:

There should be no gaps between top hinge surfaces and

HAGER TIPIT®.

Mark hole locations and drill pilot (5/32" drill) holes in frame

face. Secure HAGER TIPIT® to frame with security screws

provided.

Disclaimer:

This product is designed only as a "deterrent" to hanging objects from the top hinge surface.

HAGER COMPANIES assumes no liability due to improper installation or injury resulting from

tampering with the applied products. Sharp edges may be present at the bottom portion of

the applied hinge. It is recommended that these sharp edges (if present) be filed to

rounded edges or that a heavy bead of construction adhesive, epoxy putty or the like be

used to fill around said edges.

The Hager Tipit works on all the following models: Concealed: 750-134, 750-138, 780-110,

780-111, 780-112, 780-113, 780-114, 780-124, 780-208, 780-224, 780-226 Full Surface: 780-157,

780-210 Half Surface: 780-046, 780-053, 780-054, 780-155, 780-211, 780-259, 780-045.

HAGER TIPIT

**READ THIS FIRST BEFORE INSTALLING HINGE**

Concealed: 1" X 1" X 1"

Surface: 3-5/16" X 1" X 1"

HAGER TIPIT

Installation Instructions

I-CL00801

REV: - REV DATE: 11/29/2018

Page 1 of 1

This manual is also suitable for