2. Speakman
  3. SA-1205-BN

Speakman SA-1205-BN, SA-1209 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Speakman SA-1205-BN Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
INSTRUCTIONS FOR MODELS
92-SA-1209-R2
For additional assistance or service please contact:
SPEAKMAN
®
Company
400 Anchor Mill Road
New Castle, DE 19720
800-537-2107
customerser[email protected]
www.speakman.com
SA-1209
TOOLS AND SUPPLIES
SAFETY TIPS
Be sure to wear eye protection.
MAINTENANCE
Your new Speakman Product is designed for years
of trouble-free performance. Keep it looking new by
cleaning it periodically with a soft cloth. Avoid
abrasive cleaners, steel wool, and harsh chemicals
as these will dull the finish and void your warranty.
WARRANTY
Additional warranty information can be found at:
www.speakman.com
Level
1/4 “Tile Drill Bit
(if mounting to tile)
Rubber
Hammer
Drill with 1/4” bit
or 1/2 “bit
Phillips
Screwdriver
Flat Tip
Screwdriver
Measuring
Tape
Pencil
HELPFUL TOOLS & SUPPLIES:
REQUIRED TOOLS & SUPPLIES:
1
Place Mounting Plates into desired position
using a level to position them accordingly.
Mark mounting hole locations with a
pencil. Remove Mounting Plate from wall.
11
13
16
"
300mm
2
Option A -- Tile Wall
Option A -- Tile Wall
Drill 1/4 in. holes in the previously
marked locations.
Ø1/4 in.
2
Option B --
Option B --
Drywall with Steel Backer Plate.
Drywall with Steel Backer Plate.
Drill 1/2 in. holes in the previously marked
locations.
OR
Ø1/2 in.
3
Option A -- Tile Wall
Option A -- Tile Wall
Insert Plastic Anchors into hole and use
rubber hammer to position Plastic Anchor
flush with wall surface.
3
Option B --
Option B --
Drywall with Steel Backer Plate.
Drywall with Steel Backer Plate.
Loosely assembly toggles through Mounting
Plate.
OR
4
Option A --
Option A --
Tile Wall
Tile Wall
Insert screws through Mounting Plate and
secure Mounting Plate to wall by tightening
screws.
OR
4
Option B --
Option B --
Drywall with Steel Backer Plate
Drywall with Steel Backer Plate
Place toggle bolts through mounting holes
in wall surface.Secure Mounting Plate to wall
by tightening bolts
OR
5
Place Bracket over Mounting Plate
6
Secure Bracket by tightening set screw
at bottom.
7
Insert glass shelf into C clips.
8
Secure Glass Shelf to Brackets using Set
Screws. Tighten with Flat Tip Screw-
driver. Take care to not over tighten or
damage may occur.
9
Installation Complete.
SA-1209 ROUGH-IN DIAGRAM
DIMENSIONS SUBJECT TO CHANGE WITHOUT NOTICE.
11
13
16
"
300mm
2
3
16
"
55mm
17
11
16
"
450mm
5
1
4
"
134mm
/