Unbranded PSH4BE Product information

Unbranded
Brand
Unbranded
Model
PSH4BE
Type
Product information

Unbranded PSH4BE is a split system heat pump designed for efficient heating and cooling in residential and commercial spaces. Its key capabilities include:

  • Heating and Cooling Modes: Provides both heating and cooling functionality, allowing for year-round climate control.

  • Energy Efficiency: Utilizes advanced technology to deliver energy-saving performance, potentially reducing energy bills.

  • Variable Speed Compressor: Modulates its operation to match the changing heating and cooling needs, resulting in enhanced comfort and efficiency.

  • Quiet Operation: Engineered to minimize noise levels, ensuring a peaceful and comfortable indoor environment.

Unbranded PSH4BE is a split system heat pump designed for efficient heating and cooling in residential and commercial spaces. Its key capabilities include:

  • Heating and Cooling Modes: Provides both heating and cooling functionality, allowing for year-round climate control.

  • Energy Efficiency: Utilizes advanced technology to deliver energy-saving performance, potentially reducing energy bills.

  • Variable Speed Compressor: Modulates its operation to match the changing heating and cooling needs, resulting in enhanced comfort and efficiency.

  • Quiet Operation: Engineered to minimize noise levels, ensuring a peaceful and comfortable indoor environment.

Outdoor
Fan Motor
CC
C
H
F
Dual
Capacitor
(Single Phase)
Field Supply
L1
Grd
L2
Grounding
Screw
C
S
C
R
P
CoreSense
T1
T2
L1 L2
HPS
Contactor
R
Start
Capacitor*
Black
kcalB/wolleY
Comp
Orange
Low
Voltage
Terminals
See
Note 6
Red
Red
Defrost
Thermostat
T2
DFT
TEST
T1
T2
C
Y
O
W2
R
DFT
E
C
Y
O
W2
R
E
DF1 DF2
BlackBlack
Reversing Valve
Solenoid
CC
Black
Defrost Control Board
Yellow
CCH
Y
Black
Blue
Black
R
C
S
Route “C” Wire Through
CoreSense Module
Start Relay*
5
2
1
Black
kcalB/wolleY
Red
Yellow
Blue
Black
Gray
Yellow
Black
Yellow
Red
WIRING DIAGRAM
711206
(Replaces 710533D)
1/13
CCH
1. Disconnect all power before servicing.
2. For supply connections use copper conductors only.
3. Not suitable on systems that exceed 150 volts to ground.
4. For replacement wires use conductors suitable for 105° C.
5. For ampacities and overcurrent protection, see unit rating plate.
6. Connect to 24 vac/40va/class 2 circuit. See furnace/air handler installation
Single Phase
Split System Heat Pump (Outdoor Section)
NOTES:
1. Couper le courant avant de faire letretien.
2. Employez uniquement des conducteurs en cuivre.
3. Ne convient pas aux installations de plus de 150 volt a la terre.
instructions for control circuit and optional relay/transformer kits.
Dual Capacitor
H
C
F
Compressor
Contacts
Compressor
Outdoor Fan Motor
R
C
S
L1
T1
L2
T2
Low Voltage
Terminals
E
Defrost Control Board
DFT
Control
Logic
DF1
DF2
DFT
1
2
3
4
1
R
W2
O
Y
C
T2
T1
R
W2
O
Y
C
RVS
CC - Contactor Coil
CCH - Crankcase Heater
DFT - Defrost Thermostat
HPS - High Pressure Switch
LPS - Low Pressure Switch
RVS - Reversing Valve Solenoid
* - Hard Start Kit Field Installed
1. Closing during defrost.Rating: 1 Amp. Max.
2. Opens during defrost. Rating: 2 HP at 230 Vac Max.
3. Closed when "Y" is on. Open when "Y" is off.
Provides "off" delay time of 5 min. when "Y" opens.
4. With DFT closed and "Y" closed, compressor run
time is accumulated. Opening of DFT during
defrost or interval period resets the interval to 0.
Defrost Board Operation:
HPS
208/230V
R
PYC
CoreSense
CC
R
C
S
FIELD WIRING
LEGEND:
LOW VOLTAGE
HIGH VOLTAGE
Normal Operation, no trip
CoreSense Status LED
Normal Run; Solid Yellow
N/A N/A
N/A N/A
N/A N/A
4 cons, 10x total
4 cons, 10x total
4 cons, 10x total
1 Occurrence
10 consecutive
Red: Flash 2
Red: Flash 3
Red: Flash 4
Red: Flash 5
Red: Flash 9
Code 1; Yellow Flash 1
Code 2; Yellow Flash 2
Code 3; Yellow Flash 3
Code 4; Yellow Flash 4
Long Run Time. Compressor running extremely long run cycle. (disabled in HP mode.)
noitacidnI tuokcoLleveL tuokcoLnoitpircseD DEL sutatS
Comprsesor Pressure Trip. Disch. or suct. pressure out of limits or compressor overloaded.
Short Cycling. Compressor is running only briefly.
Locked Rotor.
Code 5; Yellow Flash 5 Compressor Moderate Run. Compressor runs >15min, then trips >7min.
Code 9; Red Flash 19 Over Current Protection. PROT terminal has >2A input for more than 40ms
Trip; Solid Red Demand but compressor is not running
  • Page 1 1

Unbranded PSH4BE Product information

Unbranded
Brand
Unbranded
Model
PSH4BE
Type
Product information

Unbranded PSH4BE is a split system heat pump designed for efficient heating and cooling in residential and commercial spaces. Its key capabilities include:

  • Heating and Cooling Modes: Provides both heating and cooling functionality, allowing for year-round climate control.

  • Energy Efficiency: Utilizes advanced technology to deliver energy-saving performance, potentially reducing energy bills.

  • Variable Speed Compressor: Modulates its operation to match the changing heating and cooling needs, resulting in enhanced comfort and efficiency.

  • Quiet Operation: Engineered to minimize noise levels, ensuring a peaceful and comfortable indoor environment.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents