2. Mopar
  3. 77072341AC

Mopar 77072341AC Installation guide

  • Hello! I'm your chat assistant. I've reviewed the installation instructions for the Mopar HighTop Fender Flare Kit, which is designed for both 2-door and 4-door Jeep Wranglers. This guide details the process of mounting the flares, outlining each step. I'm here to help answer your questions about the installation process and specific features of the kit.
  • What should I do before starting the installation?
    What should I retain from the original flare?
    What fasteners are used during installation?
1
03/20/15
www.mopar.com
JEEP WRANGLER HIGHTOP FENDER FLARE KIT
2DR / 4DR
K6862177
1/4"
2
03/20/15
www.mopar.com
K6862177
Remove and retain 6 factory
screws. Remove one retainer
from front of flare.
Remove flare by pulling out away
from vehicle.
Disconnect marker light harness.
Remove and discard J clip.
Remove any remaining retainers.
Paint shaded area black if
desired.
Drill rivets, disassemble flare.
Retain splash shield, marker
light, and wire harness.
4
Front Flare Installation
If desired, remove Wrangler
decal from both sides of vehicle.
Use heat gun.
5
1
6
1/4”
3
03/20/15 K6862177
www.mopar.com
Remove and retain clip.
Mark line using sheet metal as
guide.
Cut along marked line, discard
shaded section.
Re-install splash shield using 3
factory screws and 2 supplied
washers (E). Note: Liner moves
freely around barrel bolt.
7
Cut along marked line, discard
shaded section.
10
Secure splash shield using
forward and rearward bolts and
washers (E).
11
4
03/20/15 K6862177
www.mopar.com
Install factory clip.
Thread marker light harness
through flare assembly.
Hook marker light into housing
(DL), snap into place.
13
14
Place (DL) into marker light hole,
connect marker light harness.
Place (CL) over pocket, secure
with 4 retainers (F).
15
16
17
18
Reconnect marker light harness.
Install flare using 8 retainers (G).
Reinstall factory bolt.
5
03/20/15 K6862177
www.mopar.com
Remove 4 retainers from splash
shield. Remove flare by pulling
out away from vehicle.
Remove any remaining factory
retainers.
Drill rivets, disassemble flare.
Retain splash shield.
19
20
Secure splash shield using
factory retainers. Mark line using
sheet metal as guide.
22
Starting at front, cut along
marked line, stop mid way. See
step 24.
Continue cut along marked line,
follow molded feature in splash
shield along dashed line. Discard
shaded portion.
23
24
FRONT
REAR
Rear Flare Installation
1/4”
6
03/20/15 K6862177
www.mopar.com
Re-install splash shield using 4
retainers (J).
Install flare using 10 retainers
(G).
25
26
Depending on lift and tire combination, some trimming may be required.
/