2. Fishbone Offroad
  3. FB22047

Fishbone Offroad FB22047, FB22048, FB22049, Piranha Front Bumper Installation guide

  • Hello! I've reviewed the installation instructions for the Fishbone Offroad Piranha Series TJ Front Bumpers, specifically models FB22047, FB22048, and FB22049. This document details the steps for installing these bumpers on a Jeep TJ Wrangler from 1996-2006. I'm familiar with the different bumper styles and the included hardware, so feel free to ask me any questions you might have.
  • What tools are required for installation?
    What is included in the kit?
    How do I install the bumper?
FB22047, FB22048, FB22049
Jeep® TJ Wrangler 1996-2006
Piranha Series TJ Front Bumper
2204700
REQUIRED TOOLS
19mm Socket
15mm Socket
Socket Wrench
KIT CONTAINS
½” Hex Bolt
½” Flat Washer
D-Ring
QTY
6
6
2
FB22049 – no tube FB22048 – winch guard FB22047 - stinger
FB22047 shown with winch* and optional
winch plate* (FB21052).
*Not included
FB22047, FB22048, FB22049
Jeep® TJ Wrangler 1996-2006
Piranha Series TJ Front Bumper
1 2204700
1) REMOVE YOUR FACTORY BUMPER
Begin by removing your factory bumper. Ensure you
disconnect your factory fog lights (if equipped)
before you pull your bumper away.
2) INSTALL YOUR BUMPER
Lift the bumper up to the frame of the Jeep. Secure
the bumper to your frame in the stock bolt locations
with the supplied ½” hex bolts.
3) MOUNT YOUR D-RINGS
4) ENJOY YOUR NEW FISHBONE OFFROAD BUMPER!
/