Legrand V500 Operating instructions

V500
Legrand
Brand
Legrand
Model
V500
Type
Operating instructions

This manual is also suitable for

New installation accessories for
500
®
& 700
®
Series Metal Raceway
The new Wiremold
®
Metal Raceway Laser Level & Cutting Guide
simplifies and streamlines the process of making accurate cuts
in 500 & 700 Series Raceway during installation. The Laser Level
provides perfect visual alignment for runs of metal raceway. The
included Cutting Guide attaches to a step ladder, and provides a level
cutting channel, to ensure that raceway cuts are smooth and precise.
Speed up your raceway installation projects and get off the job faster
with the new Metal Raceway Laser Level & Cutting Guide.
Features & Benefits:
• PerfectAlignment. Special base fitting on Laser Level
attaches to outlet box base and raceway fittings to ensure
perfect alignment of raceway during installation.
• CuttingGuideattachestostepladders. Cutting Guide
attaches to step ladder to provide alignment control when
making raceway cuts.
• ChannelinCuttingGuideensuresaccuratecuts. Channel
holds raceway securely and provides stability to ensure
accurate raceway cuts.
90°
Metal Raceway Laser Level & Cutting Guide
WIREMOLD
®
installation has never been easier!
© 2013 Legrand All Rights Reserved ED1631 R1 0413
CuttingGuideInstructions:
1. Place guide with slot facing up on a ladder step.
2. Use thumbscrew to tighten in place.
3. Insert 500
®
or 700
®
Series Raceway, conduit, or threaded rod into slot.
4. Insert saw blade into channel in guide and cut the product.
LaserLevelInstructions:
The Laser Level will work with both raceway fittings and boxes.
It can also be used on other magnetic surfaces or sheetrock with
supplied push pins.
1. Rotate laser base until you feel it lock into laser level detents.
2. Use the side of the laser base to level the box base to the wall.
(See Figure 1.)
3. Rotate laser base 180° and slide laser level onto the box
tongue. (See Figure 2.)
4. Turn on laser and rotate to establish a level line using
laser level bubble.
5. Use laser level line as a guide to mark holes for raceway
mounting clips.
6. Slide laser level onto the fitting tongue. (See Figure 3.)
7. Repeat step 5.
Figure2
Figure1
Figure3
BatteryInstallation:
1. Verify that laser switch is in the OFF position.
2. Separate base plate from the laser body by removing the
center screw. (See Figure 1.)
3. Slide the battery cover off by gripping and sliding the center
protrusion toward you. (See Figure 2.)
4. Install two (2) AAA batteries and reassemble.
Figure2
Figure 1
Part Number DescriPtioN
5700cG Small Metal Raceway Cutting Guide
5700LL Small Metal Raceway Laser Level
orDeriNG iNformatioN
Metal Raceway Laser Level & Cutting Guide
ElectricalWiringSystems
60 Woodlawn Street
West Hartford, CT 06110
1.800.621.0049
www.legrand.us
570 Applewood Crescent
Vaughan, Ontario L4K 4B4
905.738.9195
www.legrand.ca
  • Page 1 1
  • Page 2 2

Legrand V500 Operating instructions

V500
Legrand
Brand
Legrand
Model
V500
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents