Coastal Shower Doors L36.66O-A Installation guide

Brand: Coastal Shower Doors

Model: L36.66O-A

Type: Installation guide

( 1 )

Legend Continuous Hinge_05-01-2015

Legend

( continuous hinge )

( 2 )

LCH_04-20-2015

LEGEND CONTINUOUS HINGE UNIT

(EXPLODED VIEW)

TSILSTRAP

TRAPYEK

RETTELREBMUNNOITPIRCSED

YTITNAUQ

A 89............................................................LLIS1

B JW404.............................................BMAJLLAW2

C 244........................................

.BMAJEKIRTS1

D ----.................................YLBMESSAROOD1

1d722......................................

...........sliaRrooD2

2d451.....................................elitSegniHrooD1

3d622........................

..............elitSekirtSrooD1

4d344...................................bmaJegniHrooD1

5d24-89................

...........................tengaMrooD1

6dB371C.......................)nwohston(lyniVgnizalG

7dLHSF2116)nwohs

ton(wercSylbmessArooD4

8d651PC)nwohston(niPegniHylbmessArooD2

E B671C........................................

...PEEWSLYNIV1

F 9231................SROHCNAWRCSCITSALP6

G 2118.....................SWERCSNOITALLATSNI6

H TPQ218.

....................SWERCSTNEMTSUJDA6

J 24-89..................................................TENGAM1

( 3 )

Legend Continuous Hinge_05-01-2015

Decide which side you want your Door to swing from then slide

Hinge Post into appropriate Wall Jamb (detail above shows unit

striking on right side).

Decide which side you want your Door to strike and slide Strike

Jamb into appropriate Wall Jamb (detail above shows unit will strike

on right side).

Position Jambs on sill, mark and drill 3/16” installation holes on walls.

Insert Screw Anchors into holes and secure Wall Jambs to walls with

1-1/2” Installation Screws Provided. Note that adjustment holes are

toward interior.

Measure opening width and trim sill to 1/16” less than measurement

obtained. Caulk underside of sill and position it on center of curb.

Insure that sill lip faces toward outside of enclosure.

( 4 )

LCH_04-20-2015

Measure Door width as shown and trim Vinyl Sweep to 3/8” less then

measurement obtained. Notch one end of Vinyl Sweep one quater inch

(approximate) as shown.

Close door and let magnets on Door and Strike Post meet. Adjust unit

as required making sure a parallel alignment is maintained between

bottom of Door Assembly and Sill. When satisfied with alignment,

secure Door Assembly and Strike Post to Wall Jambs.

Finally, caulk outside where unit meets the curb and where unit meets

the shower walls as shown. Follow caulking manufacturer’s instruc-

tions before using shower.

Insert Vinyl Sweep into Door Vinyl Slot as shown. Slot is located on

hinge side of the Door Assembly.

Coastal Shower Doors L36.66O-A Installation guide

Coastal Shower Doors L36.66O-A Installation guide

Coastal Shower Doors L36.66O-A Installation guide

Related papers

Other documents