Coastal Shower Doors GL24IL10.72N-C Installation guide

Coastal Shower Doors
Brand
Coastal Shower Doors
Model
GL24IL10.72N-C
Type
Installation guide
( 1 )
Legend Continuous Hinge_05-01-2015
Legend
( continuous hinge )
( 2 )
LCH_04-20-2015
LEGEND CONTINUOUS HINGE UNIT
(EXPLODED VIEW)
TSILSTRAP
TRAPYEK
RETTELREBMUNNOITPIRCSED
YTITNAUQ
A 89............................................................LLIS1
B JW404.............................................BMAJLLAW2
C 244........................................
.BMAJEKIRTS1
D ----.................................YLBMESSAROOD1
1d722......................................
...........sliaRrooD2
2d451.....................................elitSegniHrooD1
3d622........................
..............elitSekirtSrooD1
4d344...................................bmaJegniHrooD1
5d24-89................
...........................tengaMrooD1
6dB371C.......................)nwohston(lyniVgnizalG
7dLHSF2116)nwohs
ton(wercSylbmessArooD4
8d651PC)nwohston(niPegniHylbmessArooD2
E B671C........................................
...PEEWSLYNIV1
F 9231................SROHCNAWRCSCITSALP6
G 2118.....................SWERCSNOITALLATSNI6
H TPQ218.
....................SWERCSTNEMTSUJDA6
J 24-89..................................................TENGAM1
( 3 )
Legend Continuous Hinge_05-01-2015
Decide which side you want your Door to swing from then slide
Hinge Post into appropriate Wall Jamb (detail above shows unit
striking on right side).
Decide which side you want your Door to strike and slide Strike
Jamb into appropriate Wall Jamb (detail above shows unit will strike
on right side).
Position Jambs on sill, mark and drill 3/16” installation holes on walls.
Insert Screw Anchors into holes and secure Wall Jambs to walls with
1-1/2” Installation Screws Provided. Note that adjustment holes are
toward interior.
Measure opening width and trim sill to 1/16” less than measurement
obtained. Caulk underside of sill and position it on center of curb.
Insure that sill lip faces toward outside of enclosure.
( 4 )
LCH_04-20-2015
Measure Door width as shown and trim Vinyl Sweep to 3/8” less then
measurement obtained. Notch one end of Vinyl Sweep one quater inch
(approximate) as shown.
Close door and let magnets on Door and Strike Post meet. Adjust unit
as required making sure a parallel alignment is maintained between
bottom of Door Assembly and Sill. When satisfied with alignment,
secure Door Assembly and Strike Post to Wall Jambs.
Finally, caulk outside where unit meets the curb and where unit meets
the shower walls as shown. Follow caulking manufacturer’s instruc-
tions before using shower.
Insert Vinyl Sweep into Door Vinyl Slot as shown. Slot is located on
hinge side of the Door Assembly.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Coastal Shower Doors GL24IL10.72N-C Installation guide

Coastal Shower Doors
Brand
Coastal Shower Doors
Model
GL24IL10.72N-C
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents