AUTOTECH 10.199.023K Installation guide

Hello! I am an AI chatbot trained to assist you with the AUTOTECH 10.199.023K Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

A U T O T E C H

Installation Instructions

Phone 949.240.4000 Fax 949.240.045032240-E Paseo Adelanto, San Juan Capistrano, CA 92675

Part Number: 10.199.023K

Description: HD Polyurethane mount set, A4 Chassis trans/subframe

Notes: Our A4 transmission brace bushings reduce engine ‘rock’ under acceleration,

resulting in better power transfer

Procedure:

1) Remove the transmission brace from the car.

Using a 16mm and a 13mm wrench, unbolt the 4 bolts marked A and B (below) and remove

the brace from the car. A: 15ftlb/20Nm plus 90°; B: 30ftlb/40Nm plus 90°

www.autotech.com

1/1

2) Disassemble the brace by removing the bolt from the end.

3) Replace the rubber inserts with the new polyurethane versions. Use the diagram below as a

reference for proper location and orientation. Re-install the bolt and captive nut.

18 ftlbs / 25Nm

4) Re-install the brace on the car and tighten to specication (see step 1 for torques).