ESAB HandyPlasma 35i Declaration of conformity

DECLARATION OF CONFORMITY

According to

The Arc Welding Power Source Directive EN 60974-10:2015+A1:2015, EN IEC 60974-1:2018,

ANSI/IEC 60974-1:2008

Type of equipment

Plasma Cutting Power Source

Type designation etc.

Cutting Performance

Brand name or trade mark

HandyPlasma

Manufacturer or his authorized representative established within the EEA

Name, address, telephone No:

ESAB

2800 Airport Rd.

Denton, TX, 76207

Phone: 001 843 669 4411

The following harmonised standard in force within the EEA has been used in the design:

IEC/EN 60974-1:2017 / AMD1:2019 Arc Welding Equipment - Part 1: Welding power sources.

IEC/EN 60974-10:2014 + AMD 1:2015 Published 2015-06-19 Arc Welding Equipment - Part 10: Electro-

magnetic compatibility (EMC) requirements

Additional Information: Restrictive use, Class A equipment, intended for use in location other than residential.

By signing this document, the undersigned declares as manufacturer, or the manufacturer's authorized

representative established within the EEA, that the equipment in question complies with the safety

requirements stated above.

Date Signature Position

31-01-2020 General Manager,

Flavio Santos Accessories and Adjacencies

This manual is also suitable for