[Phaser 480 Quick Cleaning Procedure]
#8801, 3-14-95
Any comments or corrections to this document should be faxed to (503) 685-3063, Attn.: HAL Coordinator
TIPS & HINTS
Phaser 480 Quick Cleaning Procedure
3
5 671234 89
5671234 89
• Replace the paper tray.
• At the back of the printer, flip Switch 6 up.
• Flip Switch 1 up, then down.
• Wait for the motor noises (motion) to stop.
• Repeat toggle of Switch 1 three more
times, waiting each time for motor to stop.
• Flip Switch 6 down.
• Toggle Switch 1 up, then down.
• Remove paper from the paper tray and
place on a clean, dust free surface.
• Replace the cover.
• Place the cleaning sheet on the cover
of the empty paper tray:
- press the corners of the cleaning
sheet under the hooks (a);
- press the flaps into the opening in
the tray (b) and under tray cover (c);
• Dampen each of the 4 pads with at
least 20 drops of alcohol (x).
1
2
I
S
O
P
R
O
P
a
a
b
c
x
x
x
x
90%
4
• Remove the paper tray.
• Remove the cleaning sheet.
To perform Quick Cleaning you wlll need
these items, found in your cleaning kit:
1 Lint-free wipes
2 Bottle, filled with 90% isopropyl alcohol
3 Cleaning sheet (reusable)
90%
Isopropyl
To improve print quality and eliminate paper jams, your
Phaser 480 printer should be thoroughly cleaned
every time you replace the transfer roll. The procedure
below explains how to clean your Phaser 480 printer.
Try this procedure if printing is streaked or media
feeds improperly.
If you do not have a cleaning kit, call Tektronix at
1-800-835-6100, and order the Phaser 480
Cleaning Kit, part number: 016-1287-00.
PAGE 2
[Phaser 480 Quick Cleaning Procedure]
#8801, 3-14-95
Any comments or corrections to this document should be faxed to (503) 685-3063, Attn.: HAL Coordinator
7
8
• Clean the thermal head.
WARNING - head may be warm!
• Pushing towards the back of the printer,
open the gray plastic paper guide
to expose the roller underneath.
• Vigorously clean the roller inside.
- Turn the roller to reach all surfaces.
9
• Close the paper guide.
• Replace the transfer roll tray.
• Close the cover.
• Put paper in tray and replace tray.
• Wait approximately 1 minute
for Ready light.
1 min
10
5
Isopropyl
6
• Open the top cover.
• Remove the transfer roll tray.
• Dampen a lint-free wipe with approximately
ten drops of isopropyl alcohol.
• Or use a pre-moistened alcohol wipe.
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Tektronix 480X User manual
-
-
-
-
-
-
-
-
-