SUPPLEMENTARY INFORMATION
for Mitsubishi Lancer Evo V group N tarmac shock absorbers
MIR 18013, MIR 28013, MIR 38013, MIR 48013
The EVO V / VI gravel shock absorbers differ from
the EVO IV gravel units covered in the rally manual
on the following points: (The paragraph and page in
the rally manual are noted for reference.)
Picture 7, page 5:
The camber angles are different, but the step between
each bushing is still 0.4°.
Kit contents, page 5:
Your Öhlins rally shock absorbers have the following
markings:
Left front: MIR 18013
Right front: MIR 28013
Left rear: MIR 38013
Right rear: MIR 48013
Recommended settings, page 5:
Front:
Camber -3°
Spring preload 22 mm
Compression clicks 7
Rebound clicks 12
Rear:
Spring preload 30 mm
Compression clicks 7
Rebound clicks 12
Mounting instructions
Rear shock absorbers, page 6:
Points 2 and 5 including warning are deleted.
Setting up your car, pages 7:
The warning is deleted.
Technical specifications, page 7:
Front:
Stroke 146 mm
Spring rate 90 N/mm
Rear:
Spring rate 70 N/mm
Spare parts shock body front, page 8:
Pos. Part No. Pcs.
12 5177-27 1
Spare parts piston shaft front, page 8:
Pos. Part No. Pcs.
2 578-01 1
7 519-04 1
17 1069-02 2
18 1069-03 1
18A 1069-10 4
Spare parts shock body rear, page 9:
Pos. Part No. Pcs.
1 5179-01 1
2 688-19 1
3 131-04 1
Spare parts piston shaft rear, page 9:
Pos. Part No. Pcs. Descr.
9 5017-01 1
9a 338-84 1 O-ring
21 1069-02 2
22 1069-03 1
22A 1069-10 5
23 5500-04 1
26 5521-03 1
27 519-04 1
31 519-02 1
32 578-01 1
/
