UBI EasyCoder 101 – Installation Instructions
EXTERNAL PAPER ROLL HOLDER
The optional external paper roll holder can be fitted in the guide
rails either at the top or at the rear of any printer in the UBI
EasyCoder 101 family. The holder is kept firmly affixed by the
locking screw. Thread the web as illustrated below, using the
upper one of the two external paper intakes slots.
The holder is intended to accommodate a paper roll with a
maximum diameter of 180 mm (≈ 7"). When using dispensing
labels or self-adhesive strip, keep in mind that the standard type
of internal rewind unit cannot accommodate all the backing
paper from a full-sized external label roll. Thus, the rewind unit
should be checked regularly and be cleared two or three times
per label roll.
Be careful not to allow the external paper roll be contaminated
by airborne sand or grit, which may cause damage to the delicate
printhead. Always remove or cover the paper roll when cleaning
the premises, especially when dusting or sweeping the floor!
MADE IN SWEDEN
Type
Art. No.
Ser. No.
115/230 V 2.6/1.3 A 50–60 Hz
TA
PULL/TIREZ
Power
Ready
Error
EasyCoder 101
MADE IN SWEDEN
Type
Art. No.
Ser. No.
115/230 V 2.6/1.3 A 50–60 Hz
TA
PULL/TIREZ
Power
Ready
Error
EasyCoder 101
Locking screw
