Communicate via
P/N 2300-0712
6
5
7
WEEE Directive & Product Disposal
At the end its serviceable life ,this product should not be treated as
household or general waste. It should be handed over to the applicable
collection point for the recycling of electrical and electronic equipment,
or returned to the supplier for disposal.
CE Mark Warning
This equipment complies with the requirements relating to
electromagnetic compatibility of the essential protection
requirement of Council Directive 2004/108/EC on the approximation
of the laws of the Member States. Company has an on-going policy
of upgrading its products and it may be possible that information in
this document is not up-to-date. Please check with your local
distributors for the latest information. No part of this document can
be copied or reproduced in any form without written consent from
the company.
www.micronet.com.tw
Quick Installation Guide
Model No.: SP6524PWS
20G + 4G Combo
Web Smart PoE Switch,
370W
Configuration
Web-based User Interface
Before using web management, install the SP6524PWS on the
network and make sure that any one of the PCs on the network can
connect with the SP6524PWS through the web browser. The default
IP, subnet mask, and password are as follows:
IP Address: 192.168.1.1
Subnet Mask: 255.255.255.0
Password: admin
----------For more details, please refer to the user manual.--------
Introduction
Micronet SP6524PWS is a 24-port 10/100/1000Mbps Smart PoE
Switch with 370 Watts PoE output, it also comes with four shared
mini-GBIC (SFP) slots for supporting Gigabit fiber expansion.
SP6524PWS features 24 IEEE 802.3af Power over Ethernet (PoE)
ports supplying up to 15.4 watts per port. This product can convert
standard 100~240V /AC power into low-voltage DC that runs over
existing LAN cable to power up IEEE 802.3af/at compliant network
accessories. It also features PoE awareness to verify whether the
network device receive power is IEEE 802.3af/at compliant, or only
the data will be sent through LAN cable. It can detect the presence
of 802.3af compliant devices, supplies power to different appliances,
such as IP Camera, wireless AP or IP Phone to enable a unified
supply of data, voice, video and power over standard Cat.5, 5E, 6,
and 7 twisted pair cable.
Package Contents
Before you start installing the device, verify the following items are
in the package:
SP6524PWS Web Smart PoE Switch
Quick Installation Guide
Manual CD
Mounting accessory
Power cord
4
3
1 2
Key Features
Provide 24 IEEE 802.3af PoE ports, or using up to 12 PoE ports
to fulfill with IEEE 802.3at standard; power supplying up
370 Watts totally
Provide 4 Fiber (1G SFP) uplink ports
Support VLAN Tagging (IEEE 802.1Q) and IGMP for
snooping feature
Support Link Aggregation (IEEE 802.3ad) and QoS
(Port-based/IEEE 802.1p) feature
Support Port Mirroring on one Ethernet port and copy the port
data to another port for traffic analysis
Provide Mozilla Firefox, Microsoft Internet Explorer
web access management
Physical Description
Front Panel
Rear View
Hardware Installation
Connecting to an Ethernet Port for Switch Web Management
1.Connect one end of an RJ-45 cable to the Ethernet port on the
front panel and the other end to a PC or terminal for web
interface management.
Connect one end of an RJ-45 cable to the Ethernet port on the front
panel and the other end to network devices such as IP camera, IP
phone..etc. Make sure the switch port's Link LED lights up.
Cabling Requirements for 1000Base-SX/LX SFP Module
The SP6524PWS supports more complex and comprehensive
cabling using fiber media. There are two categories of fiber,
multimode and single mode. The latter is categorized into several
classes by the supported distance; they are SX, LX, LHX, XD, and
ZX. From the viewpoint of connector type, there are LC and Bi-Di
LC.
Gigabit Fiber with multimode LC SFP module
Gigabit Fiber with single-mode LC SFP module
Gigabit Fiber with Bi-Di LC 1310nm SFP module
Gigabit Fiber with Bi-Di LC 1550nm SFP module
For more details, please refer to the user manual.
1.
1.
LED Color Function
System LED
LED Green
Light when power is coming up
10/100/1000Ethernet TP Port 1 to 20 LED
LINK/ACT Green
Light when connection with remote device
is good. Blinks when any traffic is present
SPD Green/
Yellow/
Off
Light Green when TP link on 1000Mbps speed
Light Yellow when TP link on 10/100Mbps speed
Off when no link occurt
1000SX/LX Gigabit Fiber Port 21,22,23,24
LINK/ACT Green
Light when SFP connection with remote device
is good. Blinks when any traffic is present
SPD Green/
Yellow/
Off
Light Green when SFP link on 1000Mbps speed
Light Yellow when SFP link on 100Mbps speed
Off when no link occurt
LED Definition:
PoE
Green
Light on when PD is connected
PoE LED
/