Luxor WB4836W Installation guide

Type
Installation guide

This manual is also suitable for

12/15
/14
Wall-mounted Whiteboard
Instructions
Note: After assembly, remove the
protective lm from the board with
a utility knife.
Slide tray into grove
on bottom of wall
board. Snap two
horizontal chalk
lines at the heights
indicated from the
floor. If attaching to
drywall drill four
1
4
˝
holes as specied.
Insert drywall anchors
B into holes then attach
brackets A at the bottom
with screw C making
sure the bracket is in the
lowest position.
Attach brackets A at the top
with screw C making sure
the bracket is in the highest
position. Tighten screw just
enough so that the bracket
can be tapped down with
hammer.
Place white board on
lower brackets making
sure to center it with
middle lower bracket
A. Attach bracket to
wallboard using screw D
starting with the middle
lower bracket.
Tap the top brackets
down so they are
touching the top of
the board. Attach
bracket to wallboard
using screw D.
1 2 3 4 5
Parts List
- Tape Measure
- Chalk Line
- Drill
- 1/4˝ Drill Bit
- Extended Drive
Phillips
- Hammer
A x4 B x4 C x4 D x4
Tools Required
Note: Hardware provided is for drywall installation. If attaching
to other material fasteners are to be furnished by other.
Chalk Line 1˝
above the desired
bottom position.
Recommended
37
1
4˝ from oor.
1˝ space
1˝ space
Chalk Line
33
1
2˝ above the
bottom Chalk
Line
Chalk Line 1˝
above the desired
bottom position.
Recommended
46
3
8˝ from the oor.
Chalk Line
21
5
16˝ above the
bottom Chalk
Line
35
5
16˝
23
5
16˝
5
3
4˝
5
3
4˝
5
3
4˝
5
3
4˝
7
5
8˝
7
5
8˝
7
5
8˝
7
5
8˝
24˝
24˝
32˝
32˝
Drill Holes
Drill Holes
23
5
16˝ x 35
5
16˝ Board
35
1
2˝ x 47
1
4˝ Board
47
1
4˝
35
1
2˝
Drill Holes
Drill Holes
  • Page 1 1

Luxor WB4836W Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI