MyBinding Luxor WB4836LB Whiteboard Operating instructions

MyBinding
Brand
MyBinding
Model
Luxor WB4836LB Whiteboard
Type
Operating instructions
Luxor 48" x 36" Wall-
Mounted Magnetic Ghost
Grid Whiteboard
Instruction Manual
Wall-mounted Whiteboard
Instructions
Note: After assembly, remove the
a utility knife.
Slide tray into grove
on bottom of wall
board. Snap two
horizontal chalk
lines at the heights
indicated from the
floor. If attaching to
drywall drill four
1
⁄4˝
Insert drywall anchors
B into holes then attach
brackets A at the bottom
with screw C making
sure the bracket is in the
lowest position.
Attach brackets A at the top
with screw C making sure
the bracket is in the highest
position. Tighten screw just
enough so that the bracket
can be tapped down with
hammer.
Place white board on
lower brackets making
sure to center it with
middle lower bracket
A. Attach bracket to
wallboard using screw D
starting with the middle
lower bracket.
Tap the top brackets
down so they are
touching the top of
the board. Attach
bracket to wallboard
using screw D.
1 2 3 4 5
Parts List
- Tape Measure
- Chalk Line
- Drill
- 1/4˝ Drill Bit
- Extended Drive
Phillips
- Hammer
A x4 B x4 C x4 D x4
Tools Required
Note: Hardware provided is for drywall installation. If attaching
to other material fasteners are to be furnished by other.
Chalk Line 1˝
above the desired
bottom position.
Recommended
37
1
⁄4
Chalk Line
33
1
⁄2˝ above the
bottom Chalk
Line
7
5
⁄8˝
7
5
⁄8˝
7
5
⁄8˝
7
5
⁄8˝
32˝
32˝
35
1
⁄2˝ x 47
1
⁄4˝ Board
47
1
⁄4˝
35
1
⁄2˝
Drill Holes
Drill Holes
  • Page 1 1
  • Page 2 2

MyBinding Luxor WB4836LB Whiteboard Operating instructions

MyBinding
Brand
MyBinding
Model
Luxor WB4836LB Whiteboard
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents