2. Sherpa
  3. KC Gravity
KC Gravity

Sherpa KC Gravity User manual

  • Hello, I am your chat assistant, and I have reviewed the installation instructions for the KC Gravity Bar Brackets by Sherpa Equipment Company. This document provides step-by-step guidance on how to install the brackets and attach the Gravity Pro bar to your roof rack, including hardware requirements and crucial mounting details. I'm ready to answer any questions you might have about the installation process or specific components.
  • What type of KC Gravity Pro bar is compatible with these brackets?
    Where do the Sherpa lightbar brackets attach?
    How should I position the support bracket on the Gravity Pro bar?
    What is the purpose of the bump stop?
    How often should I inspect my roof rack after installing this product?
KC GRAVITY BAR
BRACKETS
INSTALL INSTRUCTIONS
REV.1
4
24 4
1/4”-20
(9/16”)
Brackets 1/4”-20 Tnut 1/4” Washer
USING TNUTS
HARDWARE CHECKLIST
Exact hardware color counts may vary based on the options selected at checkout.
Install 01
Follow the manufacturer’s
instructions on configuring the
Gravity Pro bar to your liking.
The Sherpa brackets will work if
the bar is straight or curved.
STRAIGHT
CURVED
Install 02
Flip the direction that the support
bracket faces on the Gravity Pro bar.
The flange should point downwards
toward the roof of the vehicle.
Install 03
Fasten the bump stop supplied by
KC to the support bracket that was
flipped downwards in Install Step 02
using the M8 hardware as pictured
(also supplied by KC). There are two
slots in the support bracket and a
single slot in the bump stop - utilize
one bolt per slot in the support
bracket.
Install 04
Required Components:
2 Sherpa lightbar brackets
4 1/4”- 20 x 9/16” bolt
4 1/4”- 20 Tnut
4 1/4” Flat washer
Fasten the Sherpa lightbar brackets
to the forward-most cross member
available on the roof rack using the
hardware supplied. Leave these
brackets slightly loose so that they
can be moved along the length of
the cross member to accomodate the
length of the assembled KC Gravity
Pro bar.
Install 05
Use the remaining fasteners supplied
by KC to attach the Gravity Pro bar to
the Sherpa lightbar brackets. Utilize
the mounting hole option in the
Sherpa bracket that suits your needs
the best. Tighten all fasteners down to
finalize the installation.
EXPLORE.
All products built and designed by Sherpa Equipment Company are intended for
o-road use and should be assembled, installed, and used according to Sherpa
Equipment Company’s recommendations. Sherpa Equipment Companies products
should be used safely with good judgment towards others and surroundings.
By installing Sherpa Equipment Companies products on your vehicle you assume
all liability. Sherpa Equipment Company will not be held liable for damages or loss
associated with the installation or use of its products. It is recommended that you
inspect your roof rack within the first 100 miles of installation and every 500 miles
after.
/