2. STREET AERO
  3. ACM
ACM

STREET AERO ACM Operating instructions

  • Hello! I've reviewed the provided instructions for the STREET AERO ACM Side Splitters. This document outlines the installation process, including positioning the jack stands, pre-drilling, and securing the splitters. I'm ready to answer your questions about the installation and features of these side splitters.
  • What size drill bit should I use for pre-drilling?
    Where should the jack stands be positioned?
    How does screw spacing depend on the size of the side splitter.
    Which side should the logo be facing?
    Where should I start securing the side splitter?
ACM Side Splitters
INSTRUCTIONS
[email protected]www.streetaero.com
Position the jack stand near the back
and front of the side skirt
Position the Side Splitter to the
side skirt
Street Aero Logo towards the
rear bumper
Side Splitter should reach from one
end to the other
STEP: 1
L
o
g
o
s
i
d
e
t
o
r
e
a
r
b
u
m
p
e
r
Includes: Screws (16x)
NOTE: Position the jack stand at the
Side Splitter’s pinch welds
STEP: 3
Secure the Side Splitter to the side
skirt with provided screws
Starting from the center outwards
Use extra hardware if needed
Start Mounting Here
8x
STEP: 2
Pre-drill the side skirt and Side Splitter
with 3/32” or smaller bit size
See chart below for the
recommended spacing of the screws
Pre drill holes
approximately spaced apart
Screw Spacing
8
8.5
9.25
9.8
inches
inches
inches
inches
60-70
71-75
76-80
81-86
inches
inches
inches
inches
Side Splitter Size
NOTE: Spacing may differ based on
your side skirt
/