STREET AERO ACM Operating instructions

ACM
Brand
STREET AERO
Model
ACM
Type
Operating instructions
ACM Side Splitters
INSTRUCTIONS
[email protected]www.streetaero.com
Position the jack stand near the back
and front of the side skirt
Position the Side Splitter to the
side skirt
Street Aero Logo towards the
rear bumper
Side Splitter should reach from one
end to the other
STEP: 1
L
o
g
o
s
i
d
e
t
o
r
e
a
r
b
u
m
p
e
r
Includes: Screws (16x)
NOTE: Position the jack stand at the
Side Splitter’s pinch welds
STEP: 3
Secure the Side Splitter to the side
skirt with provided screws
Starting from the center outwards
Use extra hardware if needed
Start Mounting Here
8x
STEP: 2
Pre-drill the side skirt and Side Splitter
with 3/32” or smaller bit size
See chart below for the
recommended spacing of the screws
Pre drill holes
approximately spaced apart
Screw Spacing
8
8.5
9.25
9.8
inches
inches
inches
inches
60-70
71-75
76-80
81-86
inches
inches
inches
inches
Side Splitter Size
NOTE: Spacing may differ based on
your side skirt
  • Page 1 1

STREET AERO ACM Operating instructions

ACM
Brand
STREET AERO
Model
ACM
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents