Rain-Flo Irrigation 1800 Plastic Mulch Lifter User manual

Brand
Rain-Flo Irrigation
Model
1800 Plastic Mulch Lifter
Type
User manual

This manual is also suitable for

Rain-Flo Irrigation Rain-Flo IRRIGATION 1800 Plastic Mulch Lifter is designed to remove plastic mulch from the ground efficiently. It features adjustable depth wheels and vine-cutting discs, allowing for customized performance and depth control. The lifter can be easily attached to a tractor using its Cat II lift pins and 3-point hitch. With its durable construction and user-friendly design, the Rain-Flo IRRIGATION 1800 is an excellent choice for farmers and agricultural professionals seeking an effective plastic mulch removal solution.

Rain-Flo Irrigation Rain-Flo IRRIGATION 1800 Plastic Mulch Lifter is designed to remove plastic mulch from the ground efficiently. It features adjustable depth wheels and vine-cutting discs, allowing for customized performance and depth control. The lifter can be easily attached to a tractor using its Cat II lift pins and 3-point hitch. With its durable construction and user-friendly design, the Rain-Flo IRRIGATION 1800 is an excellent choice for farmers and agricultural professionals seeking an effective plastic mulch removal solution.

CHALLENGER MODEL 1800
PLASTIC MULCH LIFTER
Assembly
Instructions
1
STEP 1
Standard Parts Shipped With Equipment:
Lifter Prong Set
STEP 2
2
CHALLENGER
MFG. BY RAIN-FLO IRRIGATION, INC.
CHALLENGER
MFG. BY RAIN-FLO IRRIGATION INC.
Install lifting prongs by sliding end through adjusting rod (B),
placing them between the brackets (A), and placing lynch pin in
position (C). Insert bolts through holes and tighten nut (D).
AAB
DDC
See Operating Manuel For Adjustments

STEP 3
3
See Operating Manuel for More Adjustments

When you receive your plastic mulch lifter, depth
wheels and vine-cutting discs will be installed but will
need adjustments.
Depth wheels are slid toward the center for shipping.
To adjust, loosen bolts shown above, slide into desired
place and re-tighten bolts. If discs need to be adjusted,
follow the same steps as shown above.
Set discs in line to cut with outside edge of plow
shank; about 2” to 3” deep.
Note: Setting disks too deep will keep machine from
going deep enough.
Depth Wheels and Vine-Cutting

STEP 4
4
See Operating Manuel for More Adjustments

Disc


Center Coulter


Depth Wheels


As shown in the Operating Manuel; coulter, disc and
wheels may need up & down adjustments. To do this,
loosen bolts shown above, slide into desired place and
re-tighten bolts.
The center coulter is to cut plastic in half for better re-
moval. When not needed, it can be removed by loosening
bolt shown above and sliding the assembly downward.
STEP 5
5

The Model 1800 has Cat II lift pins on a 3-point
hitch. Hook up 3-point top link to top of A-frame (A)
and adjust top link to level machine.
AA
6
TIPS
Machine works best if weeds and crop residue are
mowed o rst.
Adjust 3-point top link to level machine.
Drive about 2 to 4 MPH and adjust lifting rods 8” to 12”
o the ground (must be lowered if dragging results).
Adjust depth control wheels so machine lifting plows
run approx. 6” below plastic.
Adjust inside of shanks approximately 2” narrower than
original plastic width. (not bed top width)
After plastic is lifted, it is advisable to gather it up
before it rains.
❶
❷
❸
❹
❺
❻
Rain-Flo Irrigation
(717) 445-3000
~2021 Edition~
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Rain-Flo Irrigation 1800 Plastic Mulch Lifter User manual

Brand
Rain-Flo Irrigation
Model
1800 Plastic Mulch Lifter
Type
User manual
This manual is also suitable for

Rain-Flo Irrigation Rain-Flo IRRIGATION 1800 Plastic Mulch Lifter is designed to remove plastic mulch from the ground efficiently. It features adjustable depth wheels and vine-cutting discs, allowing for customized performance and depth control. The lifter can be easily attached to a tractor using its Cat II lift pins and 3-point hitch. With its durable construction and user-friendly design, the Rain-Flo IRRIGATION 1800 is an excellent choice for farmers and agricultural professionals seeking an effective plastic mulch removal solution.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents