2. Roll Hill
  3. MODL5 Modo Ceiling Mount

Roll Hill MODL5 Modo Ceiling Mount User manual

  • Hello! I'm your chat assistant. I've reviewed the Roll & Hill user manual for Modo 5 Globes and Modo 5 Globe light fixtures. I know about the installation instructions, safety information, and key features. I can answer your questions about this document or the products.
  • How many light bulbs can be installed per socket?
    What type of surfaces are suitable for mounting?
    Can Modo Chandeliers be mounted on normally flammable surfaces?
    What is the maximum ambient temperature for the fixture?
    What should be done if the external cable is damaged?
SAFETY INFORMATION
Only one light bulb per socket.
Only suitable for direct mounting on non-combustible surfaces.
Under no circumstances can Modo Chandeliers be mounted on normally flammable surfaces.
Suitable for dry, indoor use only.
Maximum ambient temperatures: 25˚ C
CONTENTS
Updated 12MAY2021 1
T +1 718 387 6132
www.rollandhill.com
Crossbar
Modo Flush Mount - 5 Globes
#8-32 Screws (2)
Globes (5)
1/8 IPS Nipple #8/32 Socket
Screws (2)
9-64 Allen Key Canopy and
mounting Bracket
Bulbs (5)
Wago Connector (2)
120V LED G25 E26
(bulbs included)
240V LED G25 E27
(bulbs included)
Updated 12MAY2021 2
T +1 718 387 6132
www.rollandhill.com
WALL INSTALLATION | MODO SCONCE - 5 GLOBE
Note: Please contact a licensed electrician.
Note: Do not use bulbs that exceed 25 watts.
1. Attach the crossbar (A) from the back of the fixture onto the juntion box using provided #8-32
screws (B). Screw the 1/8 IPS nipple (C) into the center hole of the crossbar and feed electrical wires
out from the nipple.
2. Place backplate (D) over nipple and secure by threading the mounting bracket (E) onto the nipple.
Tighten until canopy is flush against the wall and mounting bracket is positioned horizontally.
2. Hold fixture up to backplate and make electrical connections to sconce, trimming excess wire. Push
the connected wires into the half hub.
3. Fit the hub over the mounting bracket and secure in place with provided #8-32 socket screws (F)
and allen key.
DBA
EF
C
Updated 12MAY2021 3
T +1 718 387 6132
www.rollandhill.com
INSTALLATION | ATTACHING MODO GLOBES
1. Sandwich the glass globe (A) around the socket fitter (B) and cap (C). Gently tighten the sleeve (D) to
hold the globe in place.
D
C
B
A
SAFETY INFORMATION
Suitable for dry, indoor use only.
Maximum ambient temperature: 25˚C
If the external flexible cable or cord of this luminare is damaged, it shall be exclusively replaced by
Roll & Hill or Roll & Hill’s service agent or a similarly qualified person in order to avoid hazard.
The light source contained in this luminaire shall only be replaced by the manufacturer or his service
agent or a similar qualified person.
/