Page is loading ...
Product Information
User Manuals
Quick Start Guides
Specificatio Sheets
Software Upgrades
Firmware Upgrades
VISIT
www.digimerge.com
Digimerge Technologies Inc.
Copyright © 2011 Digimerge Technologies Inc.
As our products are subject to continuous improvement,
Digimerge reserves the right to modify product design,
specifications and prices, without notice and without
incurring any obligation. E&OE
IT’S ALL ON THE WEB!
Camera Specifications
ULTRA RESOLUTION
IR BULLET CAMERA
Specfications:
1/3" Sony Super HAD™ II
Video Output
Horizontal Resolution
FOV (horizontal)
Termination
Lens Focal Length / Type
S/N Ratio
Power Consumption
NTSC: 768 (H) x 494 (V)
600 TVL
69 degrees
Video: BNC Female
3.6mm F2.0 / Fixed
> 50dB (AGC off)
Internal; 2:1 Interlace
60ft (18m); 18 LED's
250mA max
Operating Temp.
-4°F ~ 122°F
Comp. 1.0 Vpp @ 75ohm
Iris & Shutter Speed
Power Requirement 12V DC ±10%
Dimensions (LxWxH)
Minimum Illumination
Video Format / Pixels
0.3 LUX @ F2.0 (IR Off)
0 LUX (IR LEDs ON)
0.3 kg / 0.7lbs
90mm x 63mm x 58mm
3.6” x 2.5” x 2.3”
Weight (with Stand)
Sync. & Scan. Systems
IR Range
Image Sensor
AES; 1/60 ~ 1/100,000 sec.
Dimensions:
63mm
2.5”
90mm
3.6”
58mm
2.3”
MODEL: DCB23DL
English Version 1.0
QUICK START GUIDE
Copyright © 2011 Digimerge Technology Inc.
www.digimerge.com
1. Connect the BNC connector of the camera to the
video cable.
2. DC Power—
Power adapto
r: Connect a 12V DC
Power Adaptor (not included) to the camera. Plug
the Power Adaptor into a local power outlet.
•DC Power—
Power Pigtail
(not included):
Connect a Power Pigtail to the camera. Connect
the terminating wires of the cable directly to the
DC power source.
NOTE: The Power Pigtail is a non-polarity input.You can connect the
wires to either the positive or negative ports of the DC power source.
Contents Installing the camera
1 x Weatherproof IR Bullet Camera
1. Mount the camera stand to the desired mounting
surface using the provided screws.
2. Attach the camera to the supplied stand at either
of the two connection points.
Features
• Sony Super HAD™ II / 600TVL
• Advanced Digital Noise Reduction (DNR)*
• 60 ft (18m) IR Night Vision Range**
•3.6mm Wide Angle Lens
• IP66 Weatherproof rating***
• Wall/Ceiling Mounting
• 12V DC Operation
*Default Setting
** IR Illumination range under ideal conditions. Objects at or beyond this
range may be partially or completely obscured, depending on the camera
application
*** Not recommended for submersion in water
WARNING - A REGULATED UL/CSA APPROVED 12V DC power supply
is REQUIRED for use with this camera. Use of a non-regulated, non-
conforming power supply can damage this product and will void the
warranty.
1x Mounting Bracket / Stand
Setting up the camera
ATTENTION - Test the camera prior to selecting a permanent
mounting location by temporarily connecting the cameras and
cables to the DVR or Observation System.
PRECAUTIONS
• Use an appropriate low voltage power cable to prevent fire or
electrical shock.
• Make sure to install the camera in an area that can support the
camera weight.
• There are no user serviceable parts inside the camera. Please
do not disassemble the camera.
• Do not clean the lens cover with an abbrasive cleaning material
Please use a soft cloth to clean the lens cover.
Setup Diagram
/