Christie WU12K-M Operating instructions

Christie
Brand
Christie
Model
WU12K-M
Type
Operating instructions

This manual is also suitable for

Label Placement Instruction Sheet 1 of 2
020-100570-01 Rev. 1 (04-2010)
Label Placement
Instruction Sheet
INTRODUCTION
If not already equipped, two (2) new safety labels (included in this package) must be affixed to the outside
skin of your M Series projector – a Power Switch Location label and a Danger Hazardous Voltage label.
Please use the following placement instructions and accompanying diagram (Figure 1) when placing these
new labels onto your projector.
LABELS REQUIRED
xLabel AC Power Switch Location (PN 013-101549-01)
xLabel Danger Hazardous Voltage (PN 013-101546-01)
INSTRUCTIONS
1. Place the AC Power Switch location label directly below the bevel and in line with the licence label
as shown in Figure 1.
2. Place the Danger Hazardous Voltage label between the two center screws in the orientation shown in
Figure 1.
2 of 2 Label Placement Instruction Sheet
020-100570-01 Rev. 1 (04-2010)
DANGER
HazardousVoltage
AlwaysplacetheprojectorACpower
switchintheOFFpositionbefore
unpluggingtheAClinecord.
DANGER
Hazardous Voltage
Always place the projector AC power
switch in the OFF position before
unplugging the AC line cord.
AC Power
Switch Location
Danger Hazardous Voltage
Figure 1
  • Page 1 1
  • Page 2 2

Christie WU12K-M Operating instructions

Christie
Brand
Christie
Model
WU12K-M
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents