2. Christie
  3. Roadster WU12K-M

Christie Roadster WU12K-M, Roadster DS+14K-M, WU12K-M, WU14K-M Operating instructions

  • Hello! I've reviewed the provided instruction sheet for the M Series Projector. This document outlines the proper placement of safety labels, specifically the AC Power Switch Location label and the Danger Hazardous Voltage label. I'm ready to answer any questions you have about affixing these labels or anything else related to the document.
  • What labels are included in the package?
    Where should the AC Power Switch location label be placed?
    Where should the Danger Hazardous Voltage label be placed?
Label Placement Instruction Sheet 1 of 2
020-100570-01 Rev. 1 (04-2010)
Label Placement
Instruction Sheet
INTRODUCTION
If not already equipped, two (2) new safety labels (included in this package) must be affixed to the outside
skin of your M Series projector – a Power Switch Location label and a Danger Hazardous Voltage label.
Please use the following placement instructions and accompanying diagram (Figure 1) when placing these
new labels onto your projector.
LABELS REQUIRED
xLabel AC Power Switch Location (PN 013-101549-01)
xLabel Danger Hazardous Voltage (PN 013-101546-01)
INSTRUCTIONS
1. Place the AC Power Switch location label directly below the bevel and in line with the licence label
as shown in Figure 1.
2. Place the Danger Hazardous Voltage label between the two center screws in the orientation shown in
Figure 1.
2 of 2 Label Placement Instruction Sheet
020-100570-01 Rev. 1 (04-2010)
DANGER
HazardousVoltage
AlwaysplacetheprojectorACpower
switchintheOFFpositionbefore
unpluggingtheAClinecord.
DANGER
Hazardous Voltage
Always place the projector AC power
switch in the OFF position before
unplugging the AC line cord.
AC Power
Switch Location
Danger Hazardous Voltage
Figure 1
/