2. Christie
  3. Roadster DS+14K-M

Christie Roadster DS+14K-M, Roadster WU12K-M, WU12K-M, WU14K-M Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Christie Roadster DS+14K-M Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Label Placement Instruction Sheet 1 of 2
020-100570-01 Rev. 1 (04-2010)
Label Placement
Instruction Sheet
INTRODUCTION
If not already equipped, two (2) new safety labels (included in this package) must be affixed to the outside
skin of your M Series projector – a Power Switch Location label and a Danger Hazardous Voltage label.
Please use the following placement instructions and accompanying diagram (Figure 1) when placing these
new labels onto your projector.
LABELS REQUIRED
xLabel AC Power Switch Location (PN 013-101549-01)
xLabel Danger Hazardous Voltage (PN 013-101546-01)
INSTRUCTIONS
1. Place the AC Power Switch location label directly below the bevel and in line with the licence label
as shown in Figure 1.
2. Place the Danger Hazardous Voltage label between the two center screws in the orientation shown in
Figure 1.
2 of 2 Label Placement Instruction Sheet
020-100570-01 Rev. 1 (04-2010)
DANGER
HazardousVoltage
AlwaysplacetheprojectorACpower
switchintheOFFpositionbefore
unpluggingtheAClinecord.
DANGER
Hazardous Voltage
Always place the projector AC power
switch in the OFF position before
unplugging the AC line cord.
AC Power
Switch Location
Danger Hazardous Voltage
Figure 1
/