Page is loading ...
© 2022 Human Active Technology, LLC P516629 REV B
7000
Installation Instructions
Human Active Technology
800 524 2744
customerservice@team-hat.com
team-hat.com
PAGE 1 OF 10
A Top Down Mount 1x
8524
B 180 Degree Rotation Stop 1x
108208-180
C M6 x 1 x 18mm Phillips Pan Head Screw 1x
105304
D Monitor Tilter 1x
8500 Tilter
E Quick Connect VESA Plate 1x
114808
F M4 x 12mm Phillips Pan Head Screw (4-pack) 1x
702096
G Dog Washer 1x
105189
H 10-32 x 3/8" FPhMS w/Lock Patch 1x
705198
I Forearm Cable Cap 1x
115584
J Cable Cap 1x
114810
K 1/8" Allen Wrench 1x
701312
L 3/32" Allen Wrench 1x
700146
M 7/32" Allen Wrench 1x
701127
Note: Parts may be shipped in separate boxes, please review all packaging prior to discarding.
PARTS LIST
PAGE 2 OF 10
M
A
OR
Desk thickness
up to 1.5" (3.8 cm)
Desk thickness
up to 1.5" (3.8 cm)
iIf the monitor arm or pole does not easily fit into the
mount, remove the bushing from the mount and place
it on the monitor arm or pole and press firmly back
into the mount.
OR
1 2
2a 2b 2c
7/32"
PAGE 3 OF 10
3
B
C
C
PAGE 4 OF 10
4
F
F
E
PAGE 5 OF 10
5
D
PAGE 6 OF 10
6
G
H
iTILTER FRICTION ADJUSTMENT
K
1/8"
PAGE 7 OF 10
7
7/32"
IMPORTANT!
• Monitor must be on arm
• Arm must be in mount
Depending on the weight of your monitor, you may have to make 15-20 turns.
If the arm drifts downward,
turn the adjustment screw
counter-clockwise.
If the arm drifts upward,
turn the adjustment screw
clockwise.
M
Press the arm down to
approximately parallel
with the desk prior to
turning the strength
adjustment screw.
In some instances, an additional
counterbalance adjustment may be
needed to allow the arm’s instant height
adjustment function to work properly.
If your arm is not staying in position
after performing step 7, tighten the
adjustment screw as shown.
1/8"
K
iOptional Adjustment
PAGE 8 OF 10
8
3/32"
L
PAGE 9 OF 10
9
J
I
PAGE 10 OF 10
/
