2. FSR
  3. HV-T6-BLK

FSR HV-T6-BLK Installation guide

  • Hello! I've reviewed the provided installation instructions for the FSR HV-T6 interconnect box. This document outlines the process for mounting the box into a tabletop, specifically noting the required hole size, fastening methods, and cable management practices. I'm ready to answer any questions you might have about the installation or features described in the document.
  • What is the diameter of the hole needed for installation?
    How many wood screws are needed to install the clamp shroud?
    What is the minimum and maximum table thickness supported?
    What are the threaded rod dimensions?
FSR 244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - Fax: 973.785.4207
43040 LIT1457A
ASSEMBLED VIEW
UNDERSIDE VIEW OF SHROUD
HV-T6 SUB-ASS'Y
INSTALL DESIRED BRACKETS INTO THE
'HV-T6' SUB-ASS'Y. DROP THE SUB-ASS'Y
INTO THE HOLE IN THE TABLE
(COVER ORIENTATION IS PRE-SET
BY THE SHROUD INSTALLATION).
INSTALL CLAMP SHROUD TO UNDERSIDE
OF TABLE HOLE WITH (5) WOOD SCREWS
AS SHOWN. ORIENT PER DESIRED
COVER SWING DIRECTION.
PASS THE DESIRED-LENGTH (2) LONG
THREADED ROD THRU THE SHROUD AND
THREAD INTO THE SUB-ASS'Y. TURN THE
LOCKING NYLON NUT UP SNUG AGAINST
THE SHROUD BASEPLATE TO PULL THE
SUB-ASS'Y DOWN COMPLETELY INTO
PLACE IN THE PRE-CUT 6.00" DIA. HOLE.
MAKE ELECTRICAL CONNECTIONS AS
REQUIRED AND TIE-WRAP CABLES TO
TIE-TABS. ENSURE HDMI CONNECTORS IN
THE SUB-ASS'Y CAN BE PULLED OUT 3'-0"
PRIOR TO SECURING CABLES TO TIE TABS.
HV-T6 INSTALLATION INSTRUCTIONS
(5) #6 / #8
MOUNTING
POINTS
2
1
4
PRE-CUT 6.00" DIA.
HOLE IN TABLE
3/4" MIN. - 2-1/4" MAX.
TABLE THICKNESS
(5) #6 / #8 x 1/2"
WOOD SCREW
3.50
7.00
5.50
5.50 7.00
2.75
2.75
3.38
9.05
(6) CABLE
TIE TAB
6.00" DIA. THRU
HOLE IN TABLE
3
(2) LOCKING NYLON NUT
(2) #6-32 x 2.00" or 3.00" LONG
THREADED ROD
/