Maintenance of the luminaires is limited to their surfaces. During maintenance no moisture can come
into contact with any areas of the terminal connections or voltage control parts.
The luminaire can be dimmed by wall switch
IP20
3X
11.5 cm
46 cm
165 cm
60 cm
I
1. Switch off the main power supply.
2. Insert and close the ends of the chain
to the ceiling rose and the Section (A)
of the lamp as shown in the picture on the
left.
3. and 4. Use screws to mount the bracket
on the ceiling.
5. Connect the electrical cable of the lamp
with the mains wire.
6. Screw the side screws provided with
the ceiling rose to mount the ceiling rose
on the bracket.
7. Connect the holder part of the lamp
(section A) to the shade part (section B)
using the threaded shade ring as shown
on the image on the left.
8. Use an E 27 threaded bulb on the
lamp holder.
9. Use the three mounting screws provided
with (section C) of the lamp (cage portion) to
mount the cage to the shade (section B).
10. Your lamp is now ready, switch on the
main power supply to light it.
3
4
5
6
2
2
9
9
5
7
8
Section A
Section C
Section B
Engine HL Black and Grey
94790
¡
Max. ø45mm
E27 Max. 40W
IP20
/
