1© Midmark Corporation 2005
MA61840211i
003-1591-00 Rev. (E) 5/24/16
Barrier-Free™ Exam Table Installation
ALWAYS leave
(4) base cover
supports in place
until final delivery.
ALWAYS transport table
in “full-down” position.
Applies to Models
222
223
623
NEVER push on base covers.
NEVER use stirrups to lift table.
NEVER use upholstered top to lift table.
Language of origin: English
Equipment Alert
Failure to follow these instructions
may result in damage to the table.
Caution
Heavy object. Can cause muscle strain or back injury.
Use lifting aids and proper lifting techniques when moving.
Note
Upholstery installation instructions
are packaged with upholstered top.
Step 1: REMOVE two lag screws going thru shipping
straps securing the table to the skid.
Slide shipping straps towards the center of
the table allowing them to fall free from slots
in the table baseplate.
Lag Screw
Lag Screw
Shipping
Strap
2
© Midmark Corporation 2005
MA8331i
MA600103i
MA622801i
Before connecting the Midmark device power cord into an electrical
power source outlet, it is recommended to contact a local licensed
electrician or a local Authority Having Jurisdiction over the internal
building power distribution to verify that the device when powered
up will comply with all local electrical codes. Use the electrical
power rating marked on the device when determining the
appropriate electrical branch circuit and outlet requirements.
For 115V rated device models with a current rating at or above
12 Amps, a dedicated branch circuit may be required if the branch
circuit protection is provided by a 15 Amp breaker.
Step 4: Connect power cord.
Note: Models with the optional receptacle have two
power cords. Both cords must be connected for
proper operation.
The power cord on models
w/o receptacle must be connected
to the table as shown.
Equipment Alert
The table must be leveled to
ensure proper operation.
Step 2: Adjust leveling screws at head
end of table as necessary
623 only
Step 3: Remove hand control & hand
control holster from drawer.
223/623 only
Step 5: Connect foot / hand control.
223: foot end.
623: foot or head end
Midmark Corporation
60 Vista Drive
Versailles, OH 45380 USA
1-800-643-6275
1-937-526-3662
www.midmark.com
-
1
-
2
Midmark 222, 223 Barrier-Free™ Examination Table (-015 thru -017) Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Midmark 604 Examination Table Wiring diagram
-
-
-
Midmark 230 Universal Procedures Chair User guide
-
-
Midmark 630 Human Form® Procedures Chair (-010 thru -013, -020 thru -023) Installation guide
-
-
-
-
Midmark 625 Barrier-Free® Examination Table Wiring diagram