Page is loading ...
Thank you for your purchase of the FineDine Water Dispensing
Valve with Stand.
If you have any questions, comments, or concerns, please email us
at finedine3@gmail.com. We will be happy to assist you.
Instructions on how to use the FineDine water dispenser valve
Made to fit 55MM Crown Top water bottles only. NOT FOR SCREW
TOPS!
These valves were made to be installed with minimal effort.
Excessive force or pressure is not recommended!
To Install
Step 1- Remove any sealed covering from water jug spout
Step 2- Take water dispenser valve and find the instructional arrows
with the words open and close. With that facing you, hold top part of
valve with one hand, and with the other hand start turning bottom
piece to the right or counter clockwise until it can’t turn anymore.
Step 3- Place valve into water jug spout. You might have to wiggle
the valve a bit to get it seated properly.
Step 4- Holding the top part of the valve, turn the bottom piece
clockwise until it stops and feels snug. If you have done it correctly,
then you should not be able to pull the valve off.
Step 5- Turn jug on its side to check for leaks. If any leaks occur.
See below on how to remove the valve, then try the installation
again.
Step 6- Place water jug onto stand. Enjoy ease of pouring water with
the FineDine dispenser valve.
To Remove
Step 1- Holding the top part of the valve gently. Turn the bottom
piece of the valve counter clockwise until it stops.
Step 2- Pull the valve off the water jug spout. It helps to pull the valve
towards you, and then pull up.
After that you are ready to use the same valve on another water jug.
/