SNOWBEAR 324-204 User manual

Owner’s Manual &

Assembly Guide

38 | P a g e SnowBear

Hydraulic Plow System

Control Valve Adjustment

THE UP/DOWN MOVEMENT OF THE SNOW PLOW CYLINDER IS CONTROLLED BY A FLOW

CONTROL VALVE. THIS VALVE IS LOCATED ON THE FRONT OF THE PUMP.

1. Loosen the nut on the flow control valve using a 11/16" socket, extension and ratcheting wrench.

2. Using the 5/32" Allen key, tighten the valve stud in all the way, then back it off (loosen) 1/4 of a turn.

3. Using an 11/16" open ended wrench, and a 5/32" Allen key to maintain the valve stud position,

tighten the flow control valve nut. If cylinder does not lower, repeat steps 1-3, but back off stud by

1/8 turn increments.

Download PDF