MODE D’EMPLOI
MODE D’EMPLOI
USER MANUAL
USER MANUAL
RST 2400
RADIATEUR
RADIATEUR
SOUFFLANT
SOUFFLANT
FAN
FAN
HEATER
HEATER
RST 2400 notice:Notice RSB 2005 18/09/07 15:18 Page 1
Page is loading ...
Page is loading ...
Page is loading ...
CAUTIONS
CAUTIONS
PLEASE READ ALL THESE INSTRUCTIONS CAREFULLY BEFORE USING THIS APPLIANCE.
• Make sure that the voltage rating on the type plate corresponds to your main voltage. If not, see your
retailer and do not connect the appliance.
• Keep out of children or incompetent persons and do not allow them to operate this appliance.
• Only use the appliance for domestic purposes and in the way indicated in these instructions.
• From time to time, check the cord for damages. Never use the appliance if cord or appliance show any sign of
damage.
• Never place the appliance under any electrical connector.
• Make sure that the connection cord does not touch any hot surface.
• Keep combustible materials such as drapes, clothing, towels away from the appliance.
• Do not cover the appliance.
• Keep the appliance at least 1 meter away from walls and any other thing, to permit a good air circulation.
• Never immerse the product in water or any liquid for any reasons. Do not use it at less than 60 cm of a
shower, a bath-tub or a swimming-pool.
• Do not use the appliance outdoor.
• Do not use if you have wet hands.
• Never use the appliance on or near hot surfaces.
• Never move or range the appliance by pulling the cord.
• To avoid any risk of burn, never move the appliance when it is hot.
• Before tidying the appliance, make sure that it is unplugged from the power and that it is completely cooled.
• Unplug the appliance before cleaning.
• Do not clean the appliance with abrasive chemicals.
• Do introduce neither metallic objects, nor fingers inside the appliance in order to protect you from electrical
shock.
• Never use accessories that are not recommended or supplied by the manufacturer. It could constitute a dan-
ger to the user and risk to damage the appliance.
• All interventions made by a non-qualified person can be dangerous; in this case guarantee conditions would
cancel. As all electrical products, a competent electrician must repair it.
THE MANUFACTURER WILL NOT ASSUME ANY RESPONSABILITY IN CASE OF NON ADHERENCE
TO THESE INSTRUCTIONS.
SAVE THIS USER MANUAL CAREFULLY.
5
ENGLISH
ENGLISH
For your comfort and safety,
ALPATEC has checked all the steps of manufacturing. The products have been
made for you to enjoy their design and easiness to use.
ALPATEC, a complete range of air conditioners, coolers, fans and
heaters for you to be completely satisfied.
RST 2400 notice:Notice RSB 2005 18/09/07 15:18 Page 5
MAIN ELEMENT
MAIN ELEMENT
SPECIFICATIONS
SPECIFICATIONS
USE
USE
- Place the appliance on a level surface.
- Plug the appliance.
- Turn the selector (1) clockwise and use the visual mark to select the desired running
mode. Set the desired power : function “ ” (only the fan function works),
power I (1200 W) or power II (2400 W).
- The operating light indicator lights when the appliance is in use.
- To switch off the appliance, turn the power control switch on O position.
6
Voltage 220 - 240 V
Power 1200-2400 W
Frequency 50 Hz
Ex : The power II is
selected
4- Grid
2- Running light
indicator
3- Adjustable thermostat
1- Power and fan
5- Handle
setting control
6- Visual mark to select the running
mode or adjust the thermostat
▲
RST 2400 notice:Notice RSB 2005 18/09/07 15:18 Page 6
THERMOSTAT SETTING
THERMOSTAT SETTING
Set the thermostat maximum. The light indicator comes on. When the room is at the required temperature,
carefully turn the thermostat anticlockwise until the fan goes off. Use the visual mark to note the position.
The appliance will now switch on and off automatically to keep the room at the desired temperature.
For antifrozen function, set power I or II and turn the thermostat to put ❆ in front of the visual mark.
SAFETY CUT-OFF WHEN OVERHEATING
SAFETY CUT-OFF WHEN OVERHEATING
This appliance is equipped of an automatic cut-off device in case of overheating. This device allows to stop
the appliance when the heat inside the appliance’s body becomes too high.
This cut-off stops the heating element.
If the appliances stops, ensure you that the opening does not be obstructed.
CLEANING
CLEANING
Before cleaning, ensure that the appliance is switched off and unplugged.
Clean the outside with a dry cloth.
From time to time, clean the inside with a vacuum cleaner on a low setting.
After each season’s use, we suggest that the appliance be cleaned with a cloth.
7
Ex : Le thermostat is on
minimum position
▲
RST 2400 notice:Notice RSB 2005 18/09/07 15:18 Page 7
Page is loading ...
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
in other languages
- français: ALPATEC RST 2400 Manuel utilisateur
Related papers
Other documents
-
Groupe Brandt TRV-500 Owner's manual
-
-
Polaroid PiMX922 User manual
-
Taurus Alpatec VB 02 Owner's manual
-
Elba DOMINO COOKING HOBS Datasheet
-
Black & Decker HX210-B5 User manual
-
-
WHITE BROWN W 140 Shan User manual
-
ROSIERES RFT 5577 Owner's manual
-
Indesit KN3C11(W)/FR S User guide