Petsafe PAC00-14647 Quick start guide
- Category
- Pet care
- Type
- Quick start guide
Mealcounter Plus
Quick Start Guide
The MealCounter Plus has 2 features:
• Counter that reminds you how many times your
pet has been fed, given medication, walked, etc.
• Resets itself nightly
Follow the instructions to ensure your MealCounter
Plus functions properly.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
CAUTION: Modification or changes to this
equipment not expressly approved by Radio
Systems
®
Corporation may void the user’s authority
to operate the equipment.
Note: This device is not water proof or water
resistant. Function will be lost if unit is dropped,
stepped on, or chewed.
FCC – USA
PAC00-14647
Basic Setup
Battery insertion should be done just before going to bed
the night of purchase.
Note: This will set the time of day in the unit that the
number of feedings or medication given will be reset
to zero daily.
1. Open case using coin slot at each end.
2. Insert one CR2032 battery into the holder,
positive (+) side up.
3. An orange light will flash for 60 seconds following
battery installation, turn solid and then stop.
Note: Ensure orange light is flashing during this
60 second period, if not check battery for proper
insertion.
4. Close case
5. Basic setup for the MealCounter Plus is now
complete.
Mounting, Placement, & Use
1. Apply the mounting of your choice
• Magnetic dots
• Double-stick adhesive tape
2. Mount to chip clip, food storage container, or
refrigerator
3. Press the button each time the pet is fed throughout
the day
• Make sure you see a green flash each time you
push the button
• Wait 5 seconds to verify count is correct
• MAX number of feedings/medication given is
six (6) per day
4. The unit displays the number of feedings by flashing
the count every four (4) seconds.
5. The unit resets itself to zero daily at the time you
first installed the battery or when you set the time
in the unit per the advanced setup below.
• Example: Beginning tomorrow, each time your pet is
fed press the button on the front of the MealCounter Plus
to indicate feeding has occurred. This will let you and
other family members know how many times your pet has
been fed for the day or if your pet has missed a feeding.
For instance, if your pet has been fed twice that day the
MealCounter Plus will flash twice every four (4) seconds.
Advanced Setup
Setting a reset time other than the time of day the
batteries were installed.
This procedure sets the current approximate time of
day so the unit knows when midnight occurs. The
device assumes 24 hour clock.
1. If battery is already installed remove the battery for
at least 15 seconds, and then re-insert.
2. Within 60 seconds (period in which orange LED
flashes every 4 seconds):
A. Hold down the button and count the number
of flashes until it represents the hour closest
to the current time of day.
8 AM = 8 Flashes
1 PM = 13 Flashes
6 PM = 18 Flashes
11 PM = 23 Flashes
B. You can also press the button in
correspondence with the time, i.e. 23 button
presses is 11:00 PM. Make sure you see a
corresponding green flash with each button
press.
-
1
-
2
Petsafe PAC00-14647 Quick start guide
- Category
- Pet care
- Type
- Quick start guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Andrew James 90 Day pet feeder User manual
-
Premier MannersMinder User manual
-
-
Qpets AF 108 User manual
-
-
YSI 5200 Owner's manual
-
AT&T Smart Sync 5 User manual
-
-
-
Feedandgo FEED AND GO User manual
