Petsafe PAC00-14647 Quick start guide

Brand: Petsafe

Model: PAC00-14647

Category: Pet care

Type: Quick start guide

Mealcounter Plus

Quick Start Guide

The MealCounter Plus has 2 features:

• Counter that reminds you how many times your

pet has been fed, given medication, walked, etc.

• Resets itself nightly

Follow the instructions to ensure your MealCounter

Plus functions properly.

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received,

including interference that may cause undesired

operation.

CAUTION: Modiﬁcation or changes to this

equipment not expressly approved by Radio

Systems

Corporation may void the user’s authority

to operate the equipment.

Note: This device is not water proof or water

resistant. Function will be lost if unit is dropped,

stepped on, or chewed.

FCC – USA

PAC00-14647

Basic Setup

Battery insertion should be done just before going to bed

the night of purchase.

Note: This will set the time of day in the unit that the

number of feedings or medication given will be reset

to zero daily.

1. Open case using coin slot at each end.

2. Insert one CR2032 battery into the holder,

positive (+) side up.

3. An orange light will ﬂash for 60 seconds following

battery installation, turn solid and then stop.

Note: Ensure orange light is ﬂashing during this

60 second period, if not check battery for proper

insertion.

4. Close case

5. Basic setup for the MealCounter Plus is now

complete.

Mounting, Placement, & Use

1. Apply the mounting of your choice

• Magnetic dots

• Double-stick adhesive tape

2. Mount to chip clip, food storage container, or

refrigerator

3. Press the button each time the pet is fed throughout

the day

• Make sure you see a green ﬂash each time you

push the button

• Wait 5 seconds to verify count is correct

• MAX number of feedings/medication given is

six (6) per day

4. The unit displays the number of feedings by ﬂashing

the count every four (4) seconds.

5. The unit resets itself to zero daily at the time you

ﬁrst installed the battery or when you set the time

in the unit per the advanced setup below.

• Example: Beginning tomorrow, each time your pet is

fed press the button on the front of the MealCounter Plus

to indicate feeding has occurred. This will let you and

other family members know how many times your pet has

been fed for the day or if your pet has missed a feeding.

For instance, if your pet has been fed twice that day the

MealCounter Plus will ﬂash twice every four (4) seconds.

Advanced Setup

Setting a reset time other than the time of day the

batteries were installed.

This procedure sets the current approximate time of

day so the unit knows when midnight occurs. The

device assumes 24 hour clock.

1. If battery is already installed remove the battery for

at least 15 seconds, and then re-insert.

2. Within 60 seconds (period in which orange LED

ﬂashes every 4 seconds):

A. Hold down the button and count the number

of ﬂashes until it represents the hour closest

to the current time of day.

8 AM = 8 Flashes

1 PM = 13 Flashes

6 PM = 18 Flashes

11 PM = 23 Flashes

B. You can also press the button in

correspondence with the time, i.e. 23 button

presses is 11:00 PM. Make sure you see a

corresponding green ﬂash with each button

press.

Petsafe PAC00-14647 Quick start guide

Brand: Petsafe

Model: PAC00-14647

Category: Pet care

Type: Quick start guide

Download PDF

report

Petsafe PAC00-14647 Quick start guide

Petsafe PAC00-14647 Quick start guide

Related papers

Other documents