WP9002 Series
Multi-system Cyclone Vacuum cleaner
Instruction Manual
This manual is suitable for
WP9002A, WP9002B, WP9002C
86-10-5741 7619
Should you have any question on this product,
please contact us by phone
Danger to the Person!Warning:
Important Notice
Important Safety Instructions
Reminder:
Note:
Skills to the Appliance!
Damage to the Appliance!
In addition, we offer the following safety advice.
The use of any electrical appliance requires the following common sense safety rules.
Primarily there is danger of injury or death and secondly the danger of damage to the
appliance.
The use of any electrical appliance requires the following common sense safety rules.
Primarily there is danger of injury or death and secondly the danger of damage to the
appliance.
These are indicated in the text by the following two conventions:
This appliance should not be operated by children or the people who is physical and
mental disabled or lack of relevant experience and knowledge, unless under the guidance
and supervision of the people who could be responsible for the user's safety. Keep the
product and lay it on the place where can not be touched by children and the person who
can not judge the dangers.
Location
Do not use or keep this product outside when it is raining.
Do not store the appliance near hot ovens or heating appliances.
Personal Safety
The plug must be removed from the socket before cleaning or maintaining the appliance.
Never modify the cleaner in any way.
Never use in the presence of explosive liquids or vapors.
Safety Notice
Never pick up inflammable or poisonous liquids such as petrol, copier toner or other volatile
substances. Never pick up acids, asbestos or asbestos dust.
Repairs to electrical appliances are only to be undertaken by trained personnel.
Unprofessional repairs will be dangerous for users.
The appliance should not be left running when unsupervised.
Product Safety
Never use the appliance without the filters being installed.
Never use the appliance to vacuum hot ashes, broken glass, sharp objects or liquids.
To protect against fire, electric shock and personal injury do not immerse wire, plug or cleaner in
water or other liquid.
Electrical Requirements
Check that the voltage on the rating plate corresponds with your house electricity supply which
must be A.C (alternating current)
If the socket outlets in your home are not suitable for the plug supplied with this appliance the
plug should be removed and the appropriate one fitted.
If you cut off the plug and let go of the wire, it will rewind into the machine.
Therefore you must pull out a length of the cable and secure it before cutting off the plug and
refitting a new one.
Reminder: The plug removed from the power wire. If severed, must be
destroyed as a plug with a bared flexible wire is hazardous if engaged into a
live socket outlet.
1. Components List And Illustrator 01
1.1 Components List
1.2 Name And Illustrator Of Components
2. Product Parameter 03
3. Assemble Instructions 04
3.1 Assemble
3.2 Attachments
4. Operation Instructions 06
4.1 Operation
4.2 Brushes Using
5. Daily Machine Maintenance 08
5.1 Power Shut Off / Wire Rewind
5.2 Dust Container & Filter: Removal & Replacement
6. Trouble Shooting 10
CONTENTS
1.1 Name And Illustrator Of Components
1.Components List And Illustrator
01
Dust Container Upper Cover
Dust Container Handle
Upper Cover Handle
On/Off Button
TPE Outer Wheel
Lower Cover
Suction Base
2.5L Dust Container
Main Body
On/Off Button
Brush Holder
Air Outlet Grid
Dust Container Release Button
Wire Rewind Button
Power Adjusting Knob
Power Wire
High Efficient Brush
Flat NozzleRound Brush
Stainless Steel Extension Tube
Components Holder
EVA Flexible Pipe Handle
02
Brushes
EVA Flexible Pipe Handle
Stainless Steel Extension Tube
Components Holder
High Efficient Brush 1
1
1
1
Main Body 1
1
1
Flat Nozzle
Round Brush
Item Quantity
1.2 Components List
2.Product Parameter
Dust Capacity 2.5L
03
Model
Voltage
Category
Rated Power
Wire Length 5M
800W700W 900W
Multi-system Cyclone Vacuum Cleaner
220-240V~,50/60Hz
WP9002A WP9002B WP9002C
3.Assemble Instructions
3.1 Assemble
1. Insert the hose connector (point 1) into the
bottom of suction base(point 2) until it clips securely
into position. (To remove the vacuum hose from the
vacuum cleaner, press the release latches.)
2. Insert the hose handle into the upper side of
Stainless Steel Tube, then rotate it clockwise to
fastening.
3. Insert the lower side of Stainless Steel Tube(point 1)
into the high efficient brush(point 2), then rotate it
clockwise to fastening.
To reduce the risk of personal injury- unplug before cleaning or servicing.
Warning:
Before assembling the machine please confirm you have received all the components
according to the ‘Components List’.
4. Adjust the length of Stainless Steel Tube
Push the slab on Stainless Steel Tube(point 1) with
your thumb, pull out the thin tube to the length that
you need. You can do it similarly while you want to
shorten the length.
04
The round brush can be rotated and adjusted, it is used
to clean surface of objects.
3.2 Accessories
2. Round Brush
Flat nozzle is used to clean surface of irregular objects,
like gaps, keyboards and windowsills.
3. Flat Nozzle
It is used to clean different object. Step the foot button(1)
it can be used to clean carpet; Put the foot button to
original, it can be used to clean tiles and wood floors etc.
1. High Efficient Brush
It can be used to hold round brush and flat nozzle, more
convenient to store.
4. Components Holder
5. Install and Remove Dust Container
Aim the bottom of the dust container to the front of the
machine, hold the handle and press down the dust
container, then install it firmly. If you need to remove
the dust container, press the upper cover and the release
button(point 1),meanwhile hold the upper cover handle,
then pull it up.
05
1
06
4.Operation Instructions
4.1 Operation
1. Please choose suitable brush according to your request.
2. Hold the plug, pull the wire out until to the yellow mark.
Red
Yellow
Please press the Wire Rewind Button when
you see the red mark, or it may offline and
damage the appliance.
3. Press ON/OFF button(1) to start the appliance.
You can control the air by slab the Air
Adjusting Knob(2) on EVA Tube Handle.
2
Reminder
Warning
3
4. Turning the Power Regulator(3) to adjust the
power of the appliance. The suction power can
be adjusted with the Handle Grip which is on the
base of the appliance, switch clockwise you can
increase the suction, turn anticlockwise you can
reduce the suction.
4
5. Press the On/Off Button(4) again to shut off the
power and stop working.
4.2 Brushes Using
Please pay more attention while cleaning stairs. Avoid personal injury or
damage,to prevent the cleaner from falling. Please always place the
cleaner at the bottom of stairs or on the floor.Do not place cleaner on
stairs or furniture, as it may result in injury or damage. Please always
ensure the handle in upright position while using.
Warning
Connect hose with vacuum cleaner and extension tube.
Connect high efficient brush to the end of tube for cleaning
Step the button (1) to control the brush with cleaning different grounds.(Refer to3-3. 2-1)
Connect round brush or flat nozzle to the end of tube, use your tools on stairs,
upholstery, furniture and more for a deep down clean.
07
1
5.Daily Machine Maintenance
5.1 Power Shut Off/wire Rewind
1. Press the ON/OFF button(point 1), shut off the
power,the machine will stop working.And pull out the
plug from the socket.
2. To return wire for storage(point2), hold plug and
press down wire release pedal on the side of the wire
reel.
5.2 Dust Container & Filter: Removal & Replacement
2
1
1
2
1. Press the button of the dust container handle (point 1) to release dust container
from the appliance.
2. Press the button of the dust container release (point 2) to open bottom cover and
release dust.
3. Hold the handle of the dust container and turn left/right to lock/unlock top cover.
4. Take the pre-motor filter out (point 3) for cleaning or replacement.
08
3
4
5. Press the button of the exhaust filter cover (point 4), take the HEPA filter out for
cleaning or replacement.
Hold Collector Filter under running water to wash. DO NOT use soap/detergent.
Keep the filter COMPLETELY DRY at least 24 hours.
Do not reassemble filter until collector filter has Completely dried.
Warning
09
6.Trouble Shooting
In order to reduce risk of personal injury - unplug before cleaning or servicing.
Warning
Cleaner won’t run.
PROBLEM REASON SOLUTIONS
Power wire isn’
outlet.
Blown fuse or tripped breaker.
Needs service.
Thermal Protector is activated
t plugged well into
Plug appliance in firmly.
Check the fuse or breaker.
Replace the fuse/reset
breaker.
Take to service center.
Unplug appliance and cool
for 30 minutes.
Cleaner can’t pick
up or get low
suction.
Dust container isn’t installed
correctly.
Dust container is full.
One or both filters are clogged.
Variable speed control is set too
low.
Review the dust container,
remove it and replace it.
Empty the dust container.
Remove both filters and clean
them.
Adjust the variable suction
control.
Dust escape from
cleaner.
Dust container is full.
Dust container isn’t installed
correctly.
Hose doesn’t install correctly.
Filter doesn’t install correctly.
Empty the dust container.
Review the dust container,
remove it and replace it.
Review the hose and install it.
Adjust the variable suction
control.
Cleaner tools can’
pick up.
t
Hose is clogged.
Dust container is full.
One or both filters are clogged.
Remove the hose and tools,
remove the obstructions.
Empty the dust container.
Remove both filters and
clean them.
10
Disposal
Protect our environment: do not dispose of electrical equipment in the dust bin.
Please return any electrical equipment that you will no longer use to the collection
organizations .
This helps avoid the potential effects of incorrect disposal on the environment and
human health.
This will contribute to the recycling and other forms of reutilization of electrical and
electronic equipment.
Information concerning where the equipment can be disposal of can be obtained
from your local authority.
Address: 6F, Aoya Building,169# Beiyuan Road,Chaoyang District, Beijing,China.
TEL.: 86-10-5741 7619
Email: puppyoo@moomv.com
Zip Code: 100101
Puppy Electronic Appliances Internet Technology Beijing Co., Ltd.
Made in China
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
Puppy Electronic WP9002B User manual
- Category
- Vacuum cleaners
- Type
- User manual
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
