Puppy Electronic S6 User manual
- Category
- Vacuum cleaners
- Type
- User manual
S6
Upright Vacuum Cleaner
Instruction Manual
CONTENTS
1. Parts List
Contents Of Packaging
Assembly
2. Important Safety Instructions
3. User Instructions
4. Troubleshooting
5. Cleaning And Maintenance
6. Other Useful Information
01
01
01
02
05
08
08
09
1. Unpack vacuum cleaner from box.
2. Remove any unwanted packaging materials such as cardboard, plastics and
Styrofoam.
3. For packaging purpose, the handle is packed uninstalled to the vacuum, attach
handle to the top of the vacuum and secure with large screw provided.
Contents of packaging
Parts List
Assembly
• Handle
• Vacuum body
• Dust container with lid
• HEPA filter
• Crevice tool
• Extension Tool
• Removable hose
• Vacuum head
• Instruction manual
01
1. To protect against electrical shock, do not immerse power cord or plug in water or
any other liquid. This is an electrical appliance. To avoid the risk of electrical shock or
serious personal injury, always operate with dry hands.
2. Close supervision is necessary when the appliance is used by or near children. This
vacuum is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning the use of the vacuum by a person
responsible for their safety.
3. Do not use the vacuum outdoors or on wet surfaces.
4. Do not allow the vacuum to be used as a toy. Close attention is necessary when
vacuum is used by or near children.
5. Do not use the vacuum with damaged cord or outlet plug. Do not use the vacuum if
it has been dropped, damaged, left outdoors, or dropped in water. Return the vacuum
to the service center for examination, repair or refund or contact customer service.
6. Do not attempt to change accessories while the vacuum is running.
7. Do not handle the plug or the vacuum with wet hands.
8. Use the vacuum only as described in this manual. The use of accessory attach-
ments not recommended by the manufacturer may cause damage to the vacuum or
personal injuries.
9. Do not put any object into openings of the vacuum. Do not use with any opening
blocked. Keep free of dust, lint, hair and anything that may reduce air flow.
10. Keep hair, loose clothing, fingers, and all parts of body away from openings and
moving parts.
11. Do not pick up anything that is burning or smoking, such as cigarettes, matches,
or hot ashes with the vacuum.
12. Do not use abrasive materials to clean the vacuum. Do not immerse the vacuum
in water.
Important Safety Instructions
02
PLEASE READ AND SAVE ALL INSTRUCTIONS
BEFORE USING THE CLEANER
When using electrical appliances, basic safety precautions should always be
followed, including the following:
13. Do not pick up liquids with the vacuum or use on wet floors.
14. Do not use the vacuum on concrete, tar, or similar rough surfaces.
15. Do not pick up pieces of string or fabrics with the vacuum.
16. Do not vacuum frayed carpets or tassels on carpets.
17. Do not use the vacuum to pick up flammable or combustible liquids such as
gasoline or use in areas where they may be present.
18. Do not use the vacuum without the dust container in place.
19. Store the vacuum indoors. Store after use to prevent accidents.
20. Do not abuse the power cord. Never carry the vacuum by the power cord or pull
the power cord to disconnect the outlet plug from an outlet; instead grasp the
outlet plug and pull to disconnect.
21. Unplug from the outlet when not in use and before cleaning.
22. Do not place on or near a hot gas or electric burner, or in a heated oven.
23. To disconnect, always turn OFF first, then unplug from wall outlet.
24. Do not run vacuum over the supply cord as this could damage the supply cord
and its insulation.
25. Do not leave appliance when plugged in. Unplug from outlet when not in use
and before servicing.
26. Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull
cord around sharp edges or corners. Do not run appliance over cord. Keep cord
away from heated surfaces.
27. Use extra care when cleaning on stairs.
It is for household use only.
03
SAVE THESE INSTRUCTIONS
NOTE: This vacuum has a polarized plug (one blade is wider than the other).
• As a safety feature to reduce the risk of electrical shock, this plug is intended to fit
in a polarized outlet only one way.
• If the plug does not fit fully in the outlet, reverse the plug.
• If the plug still does not fit, contact a qualified electrician. Do not attempt to defeat
this safety feature.
Electric power
If the electric circuit is overloaded with other appliances, your appliances may not
operate properly. The appliances should be operated on a separate electrical circuit
from other operating appliances.
Although the vacuum is easy to operate, for your safety, the warnings below must
be followed:
1. Do not place the vacuum near a heat source.
2. Do not unplug by pulling on the power supply cord.
3. The vacuum must be unplugged:
A. Before any cleaning or maintenance.
B. If it appears to be faulty.
Before using your vacuum, make sure that the dust container is in the locked
position and that all filters are in place.
NEVER operate this vacuum without any of the filters.
WARNING
A thermal cutout switches off the cleaner to prevent overheating if it is used when
full or there is a blockage or filters are dirty. If this should happen, switch to OFF,
unplug and troubleshoot. It will take about 45 minutes for the cutout to
automatically reset.
WARNING
04
Read and understand all instructions. Failure to follow all instructions listed below
may result in electric shock, fire or serious personal injury. The warnings, cautions,
and instructions discussed in this instruction manual cannot cover all possible
conditions and situations that may occur. It must be understood by the operator
that common sense and caution are a factor which cannot be built into this
product, but must be supplied by the operator.
WARNING
WARNING
Polarized plug
How to turn on/off the vacuum?
1. Plug into a power outlet
2. The removable hose must be placed securely in the hose
receptacle.
3. Press the on/off button to turn on. (The button is on the right
side of the vacuum head)
4. Press the on/off button again to turn off.
5. Unplug the vacuum after each use.
How to use the floor care control selector?
1. The control selector raises and lowers the height of the nozzle.
2. Make sure the vacuum is in the upright (parked) position and move the selector to
the required setting for the type of floor covering.
Setting
#1 Hard floors - best performance and energy efficiency, short to medium tile
carpets, hard wooden floors, wooden floor boards with crevice, ceramic tiles.
#2 Low pile - Low pile carpets, delicate floor covering such as vinyl, linoleum, parquet
flooring.
#3 and #4 Medium/High pile - For long pile carpet, the motion resistance may
increase, use these intermediate settings to reduce the force required to push the
vacuum
#5 Tool mode - Luxury carpet and tool mode.
IMPORTANT
Using this vacuum for loop pile carpets with pile greater than 1 inch (30mm) is not
recommended. Consult the carpet manufacturer’s recommended cleaning
instruction before vacuuming.
Note:
1. When cleaning delicate hard floor such as vinyl or linoleum, the control switch
must be moved to position.
2. Failure to do so may cause damage to the floor.
05
User Instructions
4
3
1
2
5
Vacuum cleaner release
1. Press the pedal on the left near the base connected to the vacuum head and pull
downwards on the handle to release the vacuum.
2. Push upwards on the handle to lock into upright (parking) position.
How to use the accessories
1. The crevice tool is used for cleaning radiators, corners, edges, drawers.
2. The dust brush is used for cleaning curtains, shelves, bookshelves, lamps and
other delicate objects.
3. The pet brush is used for pet hair & allergen remover. NEVER touch the rotating
brush.
4. The extension pole is used for extended reach and to add extra strength to your
hose.
IMPORTANT
When using cleaning tools, the vacuum must be kept in the upright position, particu-
larly when cleaning stairs. The height should also be set to tool mode.
NOTE: All accessories can be used being attached to hose alone or with the
extension pole attached to the hose. When vacuuming stairs, always work with the
vacuum positioned up against the bottom step.
How to empty the dust container
CAUTION: Always be sure that the vacuum is switched to OFF and unplugged
before attempting to empty the dust container.
1. Press the dust container release button to detach the dust container from the
vacuum body. Then press the dust container dirt release button at the bottom of the
dust container and empty into the trash receptacle.
06
How to clear a blockage
Low suction or poor pick up may be due to a clog in the vacuum. If you notice a
change in the sound of the motor or a reduction in performance, check for clogs.
CAUTION: Always be sure that the vacuum is switched to OFF and unplugged
before attempting to remove a clog.
1. Empty dust container.
2. Check dust container for buildup.
3. Check both the HEPA and exhaust filters.
4. Remove hose and check for clogs at either end or inside.
5. Check for clog in vacuum head. Turn the vacuum over and rotate the brushes to
identify any obstructions including hair.
How to change the belt or brush
If the vacuum is not picking up efficiently, the belt or brushes or both may need to be
cleaned or replaced. But first, make sure to troubleshoot by emptying the dust
container, cleaning the filters and checking for blockages.
CAUTION: Always be sure that the vacuum is switched to OFF and unplugged
before attempting any maintenance.
1. Turn the vacuum over and remove the 6 screws attaching the guard to the base.
Remove the brush guard, brush and belt and check for wear on the belt and/or
debris on the brush. Loop the belt around the motor and brush channel.
2. Hold the brush and stretch the belt until the brush can be slotted back into the
vacuum head housing. Rotate the brush to ensure free movement of the belt.
Replace the brush guard and tighten screws until secure.
2. Once emptied, gently tap or shake the container to release any excess dust from
the filters.
3. Close the dust container dirt release door.
4. Place bottom of the dust container into the vacuum body. Press firmly until you
hear an audible click.
07
1. Has the cleaner overheated?
• Allow vacuum to cool and rest for 45 minutes
2. Are the filters blocked?
• See cleaning instructions on how to properly clean all filters
3. Is there a working electricity supply to the vacuum?
• Check with another electrical appliance or try another electrical supply
4. Is the hose or vacuum head blocked?
• See “how to clear a blockage”
5. Is the floor selector height set correctly?
• See “floor care control selector”
6. Is the brush rotating?
• Check that the brush is rotating
WARNING
A thermal cutout switches off the cleaner to prevent overheating if it is used when
full or there is a blockage or dirty filters. If this should happen, switch to OFF, unplug
and troubleshoot. It will take about 45 minutes for the cut out to automatically reset.
CAUTION: Always be sure that the vacuum is turned OFF and UNPLUGGED before
cleaning or attempting to store the item. NEVER IMMERSE THE MOTOR in water
or any other liquid. NEVER operate the vacuum without the dust container and
filter in place.
How to clean the filters
1. Turn the dust container lid. Remove the filter assembly from the dust container
lid by rotating the filter. It is recommended that the filters washed every 5 dust
container empties. Separate the honeycomb filter and cotton filter, then gently tap
both filters to release any excess dust.
Troubleshooting
Cleaning and maintenance
08
Storing
• Store the vacuum in a dry location.
• Do not place any heavy items on top of vacuum during storage as this may result
in possible damage of the vacuum.
• Caution: Any electronic or electrical appliance should not be stored in or exposed
to areas of high heat or humidity. Do not store your vacuum close to stoves,
radiators, furnaces or in a bathroom or bathing area.
Environmental protection
If the appliance should no longer work at all, please make sure that it is disposed of
in an environmentally friendly way.
Technical specifications
2. Wash both cotton filter and honeycomb filter under warm water until the water
runs clean and clear. Remove excess water by shaking both filters. Leave to dry for
24 hours. Reassemble filter and refit back into dust container lid, only when
completely dry.
3. Exhaust Filter – The exhaust filter is located at the bottom of the vacuum. Press
the latch and pull the exhaust filter grill away from the vacuum.
4. Pull the bottom of the filter outward so the top of the filter unhooks from the filter
recess. The exhaust filter can be lightly rinsed with warm tap water. Please make
sure that the exhaust filter is completely dry before the next use.
How to clean the dust container
1. Remove the dust container lid and filters from the dust container.
2. The dust container can be rinsed with warm soapy water and dried with a soft
cloth. Please make sure that the dust container is completely dry before next use.
09
Other useful information
Model Number S6
Rating Voltage 120V ~ 60Hz
Rated Current 10A
Made in China
Address: 6F, Aoya Building,169# Beiyuan Road,Chaoyang District, Beijing,China.
TEL.: 86-10-5741 7619
Email: puppyoo@moomv.com
Zip Code: 100101
Puppy Electronic Appliances Internet Technology Beijing Co., Ltd.
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
Puppy Electronic S6 User manual
- Category
- Vacuum cleaners
- Type
- User manual
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
