Intratone EEN-PAD Owner's manual

Brand
Intratone
Model
EEN-PAD
Type
Owner's manual
Connecting a name scrolling panel
to the Intratone Residential central unit
Page 1 / 2 V231 – 0027 – AB
Fitting and connecting the panel to a central unit
Fitting and connecting the panel to a central unitFitting and connecting the panel to a central unit
Fitting and connecting the panel to a central unit
Residential
Important notes
EC standards:
- The panel unit complies with the R&TTE Directive 1999/5/EC: electrical safety standard
EN 60950(2001)applied, EMC standard EN 301 489-3 (2002) applied, radio standard EN
300 330-2 (2001) applied.
- The panel complies with the telephone network standards TS-103 021 and TR-103 000.
Cabling:
- -The cables connected to the central unit must not be placed in the vicinity of other sources of
electrical power (e.g. mains power supply).
Operating warranty
- The panel is guaranteed to operate within a temperature range of between -20°C and +70°C in
which relative humidity does not exceed 70%.
End of life product recycling:
The panel and its accessories must not be disposed of with unsorted municipal waste, but
must follow the WEEE (Waste Electrical and Electronic Equipment) collection and
recycling channel.
• Fit the tip to a hex shaped tool or to a reversible screwdriver.
• Unscrew the panel's 6 screws
• Remove the front and place it so that you can read the terminal block numbers.
• Fit the box in its built-in wall mounting.
Note: Cable pass throughs in the box will allow you to pass the cables.
• Wire the panel to one of the central unit's terminal's as shown below.
Warning: You cannot connect two panels to the same terminal on the central unit.
• Screw the front of the panel back onto the box.
Scr
Connecting a name scrolling panel
to the Intratone Residential central unit
Page 2 / 2 V231 – 0027 – AB
Cabling of a panel connected to connector 2
Size of the built-in wall box
• Do not connect 2 panels in parallel.
• With a PSTN line, connector no.1 can be
connected to a panel.
• With a GSM unit, connector no.1 cannot
be connected to a panel.
Central unit terminal
blocks
+
-
1
2
3
4
5
6
7
8
9
1
1
1
11
13
14
15
16
17
18
19
C
R
T
12
1
2
3
4
5
6
7
8
9
1
1
1
21
23
24
25
26
27
28
29
C
R
T
22
1
2
3
4
5
6
7
8
1
3
4
5
6
V
V
2
Connector 1
11 to 19 and CRT
Length - Diameter
Max 100 m using 0.6mm
Max 200m using 0.9mm
Panel card's terminal
blocks
Connector 2
21 to 29 and CRT
  • Page 1 1
  • Page 2 2

Intratone EEN-PAD Owner's manual

Brand
Intratone
Model
EEN-PAD
Type
Owner's manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents