2. Ridetech
  3. 11349571

Ridetech 11349571 Operating instructions

  • Hello! I've reviewed the Installation Instructions for the ridetech C10 1965-1966 Steering Kit. This document outlines the components included in the kit, such as tie rod adjusters, jam nuts, and tie rod ends. It emphasizes the importance of proper thread engagement and use of antisieze compound. I'm ready to answer any questions you may have about its contents.
  • What is the purpose of the tie rod adjuster?
    Which side of the tie rod adjuster is left hand threaded?
    What is the minimum thread engagement required for the tie rods?
1812-482-2932
Installation
Instructions
Recommended Tools
www.ridetech.com
Major Components .....In the box
QTY Part Number Description
2 90000090 Tie Rod Adjuster
2 99800002 5/8”-18 Right Hand Jam Nut
2 99800003 5/8”-18 Left Hand Jam Nut
1 90003043 Idler Arm
2 90003048 Outer Tie Rod End - 7.250” Long(from grease zerk) - 5/8”-18 Left Hand Thread
2 90003049 Inner Te Rod End - 7.250” Long(from grease zerk) - 5/8”-18 Right Hand Thread
Part # 11349571 - 1965-1966 C10 Steering Kit
NOTES:
This Tie Rod Adjuster is designed to take place of the OEM steel sleeve.
One end of the adjuster has a groove cut in it, this is the LEFT HAND threaded side.
When installing the Tie Rod Adjuster, use antisieze compound on the threads.
FOR YOUR SAFETY, THE TIE RODS NEED A MINIMUM 15/16” OF THREAD ENGAGEMENT INTO THE
TIE ROD ADJUSTER. USE THE SIGHT HOLE IN THE SIDE OF THE TIE ROD ADJUSTER TO ENSURE
PROPER THREAD ENGAGEMENT.
REV2 7/30/20
/