Baseus K01A Wireless Tri-Mode Keyboard
User Manual
Before using the product, thoroughly read this manual. Keep the manual for future reference.
1. Content
Keyboard×1
User manual×1
Warranty card×1
2.4G USB receiver×1
2. Specifications
Name: Baseus K01A Wireless Tri-Mode Keyboard
Model No.: K01A
Operating Voltage: 3V
Operating Current: 2mA
Compatible System: Windows, Apple OS, Linux, Harmony OS, Android
3. Connection Instructions
2.4G Connection Mode
1. Install two AAA batteries, and press the power button on the right upper corner, the keyboard will enter
the 2.4G connection mode.
2. Take out the USB receiver and connect it to the computer, and wait for the computer to install the driver,
then you can use the keyboard.
3. If step 1 and step 2 fail to pair, please press and hold "esc" and "+" at the same time to enter 2.4G forced
pairing, during when the LED flashes green, and repeat the step 2 above.
BT Connection Mode
1. Press the BT1 button on the keyboard and the indicator flashes slowly, entering the BT1 mode.
2. Press and hold the BT1 button for 3s and the indicator flashes quickly, entering the BT1 searching mode.
Turn on wireless on your computer, and select “Baseus K01A-BT3.0” to connect if your operating system is
Win 7 or earlier, or select “Baseus K01A-BT5.0” to connect if your operating system is Win 8 or above.
Function Description:
Note: The multifunction key is to test the built-in software, due to different codecs, other APPs may be
different.
4. Attention
Indicator flashes red, meaning the battery is low, please change the batteries.
When the keyboard shuts down itself or stops working, it means the battery is to low to maintain operation,
please change the batteries immediately.
Please remove the batteries if you decide to not use the keyboard for a long time.
Actual battery life may vary depending on your personal use habit or use environment.
Warning: Keep the product away from fire sources, and DO NOT attempt to personally disassemble
or modify the product, please contact customer service for help if you have any problems with the
FCC NOTE：
This device complies with Part 15 of the FCC Rules.Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
Any Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
-- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in
portable exposure condition without restriction.
/
