2. Herman Miller
  3. My Studio Environments

Herman Miller My Studio Environments Product Instructions

  • Hello! I've reviewed the instructions for the Herman Miller Wall Transom 1B1R59. This document provides a detailed guide on how to install the center wall transom, including the necessary tools and steps. I am here to help you with any questions about this device and its setup, feel free to ask!
  • What tools are required for the installation?
    What is the torque specification for tightening the Draw Rods?
    What should be done with the installation instructions?
My Studio Environments™
Center Wall Transom
Installation
A1BMVYRLS FOR PROD MEK PG 07/08/05
INSTRUCTIONS-
CENTER WALL TRANSOM INSTALLATION
MAKE FROM 115160
MEK 06/18/04 PG 06/18/04
KEF 04/04/07
13
1B1R59
1B1R59
REV PROD NAME MEK PG 4/21/06
1BSKRB
C1BY93REV TOOLS; STEP 4:
TORQUE SPEC WAS 120 IN-
LBS MEK KEF 04/04/07
1B1R59 REV C
My Studio Environments™ Center Wall Transom Installation
Tools Required:
Center Wall Transom
5/32 Allen Wrench
Part Included:
B
AC
E
D
Rail End Top Cap (2)
Ganging Clip
Draw Rod (2)Stile (2)
FShutter Guide
5/32 Hex Bit
Torque Wrench 1. Set Stiles at ends of Center Walls. Make sure side with Notch
1
2
A
1
. Install Ganging Clips where Stiles are back to back.
E
Notch
faces in for end of run and out for back to back installation.
IMPORTANT: Save these instructions for layout changes.
1B1R59 REV C
3
1. Press End Caps onto ends of Rail.
1. Set Rail onto Stiles.
4
B
C
D
C
D
2. Secure Rail to Stiles with Draw
Rods. Tighten to 80 in-lbs.
1. Press Shutter Guide onto Top Rail of Spine Wall frame.
Shutter Guide
5
Top Rail
/