Howdens MOD0003 User guide

Brand: Howdens

Model: MOD0003

Type: User guide

This manual is also suitable for

Howdens MOD0003 is a versatile tool that can be used for a variety of tasks, including measuring, marking, cutting, and securing. It is perfect for both DIY enthusiasts and professional contractors alike.

With its easy-to-use design and accurate measurements, the Howdens MOD0003 makes it easy to get the job done right. Whether you're hanging pictures, installing shelves, or building furniture, this tool is sure to come in handy.

Here are just a few of the things you can do with the Howdens MOD0003:

Measure and mark precise lengths and angles
Cut straight lines and mitered corners
Secure materials together with nails or screws

Here are just a few of the things you can do with the Howdens MOD0003:

Measure and mark precise lengths and angles
Cut straight lines and mitered corners
Secure materials together with nails or screws

Suggested Products:

Decorative Panel Mould: MOD0005

Stripwood: MOD0008

Skirting: MOD0801

Fig.1

Measure up to your preferred height for the wall panelling.

Draw a horizontal line across wall using straight edge ensuring

line is level (Fig 1).

Measure, mark and cut horizontal strips for top and bottom.

Apply bead of adhesive to back of panel strips. Offer top strip to

line and check using spirit level. Secure in position using nail gun.

Apply bottom strip and secure. NB before proceeding, please

check for any cables and pipes using a detector (Fig 2).

Measure, mark and cut strips for left and right sides.

Check level and install as before (Fig 3).

Mark centre locations of side panel strips where they join top

and bottom strips. Measure distance between centres and divide

by preferred number of panels going across

Example:

- Centre distance = 3532mm ÷ 7 panels = 504.5mm centres

- Measure and mark centres along edges of top and bottom strips

(Fig 4).

- Measure between top and bottom strips. Cut vertical strips.

Fig.2

Fig.3

Fig.4

Shaker & Panel Mould Half Wall Panelling Fitting Instructions

Fig.1

Measure and mark centres on both ends on all vertical strips.

Apply adhesive to back of strip and offer between top and bottom

strips so that the vertical strip centres are aligned with the centre

marks on top and bottom strips. Check square with spirit level and

secure using nail gun (Fig 5).

Repeat for remaining vertical strips.

Next, measure the internal height and width of each panel square/

rectangle. Cut panel moulds to length with mitred corners (Fig 6).

Apply adhesive to panel mould back and offer up to wall and

corresponding panel edge. Pin in place to secure (Fig 7).

Repeat for each panel until all panel mouldings are ﬁtted and

secured (Fig 8).

Fig.5

Fig.6

Fig.7

Fig.8

Shaker & Panel Mould Half Wall Panelling Fitting Instructions

Cut top capping mould to length. Apply adhesive to back of

moulding and pin in place to secure (Fig 9).

Fill any joint gaps.

Sand to a smooth ﬁnish then you are ready to paint.

Fig.9

Shaker & Panel Mould Half Wall Panelling Fitting Instructions

Technical Helpline:

Freephone 0800 085 3475

Howdens MOD0003 User guide

Brand: Howdens

Model: MOD0003

Type: User guide

This manual is also suitable for

Here are just a few of the things you can do with the Howdens MOD0003:

Measure and mark precise lengths and angles
Cut straight lines and mitered corners
Secure materials together with nails or screws

Download PDF

report

Howdens MOD0003 User guide

This manual is also suitable for

Howdens MOD0003 User guide

Related papers

Other documents