2. Howdens
  3. MOD0001

Howdens MOD0001, MOD0007 User guide

  • Hello! I have reviewed the HOWDENS Panel Mould & Dado Wall Panelling Fitting Guide. This document provides instructions for installing wall panelling using products such as the MOD0001 dado rail, MOD0007 cover mould, and MOD0813 skirting. It includes detailed steps on measuring, cutting, and securing panels and mouldings. I'm ready to answer any questions you have about the products or installation process described in the guide.
  • What is the suggested product for a decorative dado rail?
    What is the suggested product for decorative cover mould?
    What is the suggested product for skirting?
Suggested Products:
TM904 TM482
TM561 TM1065
Panel Mould & Dado
Wall Panelling
Fitting Guide
Suggested Products:
Decorative Dado Rail: MOD0001
Decorative Cover Mould: MOD0007
Skirting: MOD0813
Fig.1
Measure up approx 1000mm and draw a horizontal line across
face of wall using a straight edge and sprit level. This will be used
to locate top edge of dado rail (Fig 1).
Cut dado rail to length. Apply adhesive to back of moulding and
offer up to horizontal line. Secure using a nail gun (Fig 2).
Decide how many panels you would like to run across the wall.
Please bear in mind that the panels will need spacing equally.
For this example we are using a spacing gap of 150mm for both
horizontal and vertical spacing.
Example:
- Wall measures 3600mm long (Fig 3)
- Number of panels required is 4
- There will be 5 spacings x 150mm = 750mm
- Subtract spacings total from wall length 3600 – 750 =2850mm
- Divide 2850mm by 4 panels = 713mm panel width
Next, measure and mark a straight line 150mm from walls, ceiling
and from dado and skirting (Fig 4).
Fig.2
Fig.3
Fig.4
Panel Mould & Dado Wall Panelling Fitting Instructions
From the 150mm lines marked from left hand wall, measure
panel width across and draw a vertical line. Then measure
150mm across to the start of next panel and draw vertical line
then next panel width. Continue until all panels have been
drawn out onto wall (Fig 5).
To work out panel heights, measure vertically between
150mm lines for top panels and bottom panels (Fig 6).
Cut panel mouldings to correct length and mitre the corners
(Fig 7).
Take corresponding moulding and apply adhesive to back face.
Offer edge of moulding up to line ensuring that the corners are
aligned with the corners drawn out on wall.
Secure with nail gun (Fig 8).
Fig.5
Fig.6
Fig.7
Fig.8
Panel
Width
Panel
Width
Panel
Width
Panel
Width
Panel Mould & Dado Wall Panelling Fitting Instructions
Repeat procedure for all remaining panels (Fig 9).
Fill any joint gaps.
Sand to a smooth finish then you are ready to paint.
Fig.9
Panel Mould & Dado Wall Panelling Fitting Instructions
Technical Helpline:
Freephone 0800 085 3475
/