2. Concept2
  3. MODEL E

Concept2 MODEL E Reboxing Instructions

  • I have reviewed the user manual for the Model E Indoor Rower. This document provides step-by-step instructions for reboxing the rower using provided foam blocks and boxes, detailing the correct placement of components such as the flywheel, foot supports, and monitor arm. I'm ready to answer any questions you have about this process.
  • What tools are needed for reboxing?
    Where should Box 3 be placed?
REBOXING MODEL E INDOOR ROWER
concept2.com | 800.245.5676 1213
Flywheel foam block #1
Foot support
foam block #2
Cross foam block
Slot for Box 3
Foot support foam block #3
TOOLS NEEDED: 6 lobe driver, packing tape
Front end and monorail assemblies
nested together
REBOXING BOX 1
1
2
3
REBOXING MODEL E INDOOR ROWER
1
REBOXING BOX 3
Repack Box 3 items, taking care to protect
the PM4. Place Box 3 monitor side DOWN
into slot in foam in Box 1. See Step 3 on
other side for Box 3 location.
BOX 2
Contents
Protective
cardboard
(shown folded)
Monitor
Arm
Front Leg
Assembly
Rear Leg
Assembly
REBOXING BOX 2
Place front leg in box.
Note orientation.
2
b. Slide these
parts into the
box alongside
the front leg.
Side view
of Box 2
contents.
concept2.com | 800.245.5676 1213
a. Place rear leg and monitor
arm in folded cardboard as
shown, noting their orientation.
/