2. Concept2
  3. Dynamic Indoor Rower

Concept2 Dynamic Indoor Rower Reboxing Instructions

  • I've reviewed the user manual for the Dynamic Indoor Rower. It provides detailed, step-by-step instructions on how to properly rebox the rower and its components for shipping or storage. The manual contains step-by-step instructions with clear images. I am ready to answer any questions you have.
  • How do I prepare the front leg/monitor arm assembly for packing?
    What should I do with the shuttle before packing it?
    How should I secure the flywheel return assembly?
    What is the next step after wrapping the flywheel return assembly?
CONCEPT2.COM
Page 1 0811
3. Tape large inner box shut.
REBOXING THE DYNAMIC INDOOR ROWER
4. Slide shuttle into plastic sleeve and place into the
small inner box. Tape up box.
5. Wrap seat to end of rail assembly. 6. Wrap box around rail assembly.
Box 1
1. Place front leg/monitor arm assembly into
large inner box. Place packing material under
performance monitor, monitor arm swivels and
leveling feet.
2. Wrap packing material around performance
monitor, monitor arm swivels and leveling feet. Fold
reinforcing cardboard over the monitor.
CONCEPT2.COM
Page 2 0811
7. Position the large inner box in the bottom of the large
shipping box. Place the rail assembly, shuttle channel
and rear foot assembly boxes on top of the large inner
box. Close and tape box.
Rail Assembly
Shuttle Channel
Rear Foot
Assembly
Large
Shipping
Box
REBOXING THE DYNAMIC INDOOR ROWER
Box 1 continued
Box 2
1. Place foot carriage in one half of foam insert. 2. Place other half of foam insert on opposite side of
foot carriage.
3. Position filler box against bottom of foot carriage/
foam assembly.
4. Wrap stretch wrap around foot carriage and filler
box. Ten wraps is sufficient.
Box 2
CONCEPT2.COM
Page 3 0811
5. Position flywheel return assembly with the
flywheel facing up.
6. Protect assembly box arm and handle by wrapping
them with stretch wrap.
REBOXING THE DYNAMIC INDOOR ROWER
Box 2 continued
7. Wrap flywheel with stretch wrap. Three wraps is
suffucient.
8. Position the flywheel return assembly so that the
flywheel is facing down.
9. Hold handle against top of return mechanism box
and wrap with stretch wrap.
10. Center foam u-block under the return mechanism box
under the letters “ep” of the Concept2 logo.
CONCEPT2.COM
Page 4 0811
Box 2 continued
11. Place foam u-block with plastic protector at
end of return mechanism box and wrap all with
stretch wrap.
12. Slide return mechanism box into foot carriage
packaging.
REBOXING THE DYNAMIC INDOOR ROWER
13. Coil drive cord and wrap against return mechanism
frame.
14. Add top foam cross-block.
15. Tape box.
/